Routing

Hello Everyone,I have three general questions regarding our new T3 router configuration.Question 1:The I received the first bit of config info from the ISP:interface Serial1/0ip address 10.0.0.1 255.255.255.252encapsulation pppload-interval 30dsu ban...

I'm trying to determine the best way to prefer 1 default route over the other. I have a dozen or so remote sites and all of them need to prefer the same default route except for 1 location. I've prepended my AS to the less desirable default route a...

Hi, our serial interface recently went down and I'm trying to figure out why but I'm not sure what the lights on the card mean. The lights on the card are LP, AL, CD. The LP light is blank, the AL light is orange, and the CD light is green, but bo...

I have to create access to the list of services via NAT.Some times inside global IPs (IP that is seen to remote side) are equal for different services.What is the best practice - create pool on per service basis, e.g.ip nat pool SERVICE1 1.1.1.1 1.1...

I am attempting to do a password recovery on a Catalyst 2955 but it will not accept a break sequence to allow me into flash (there is no mode button on this model). I have tried several terminal clients (Secure SSH, Putty, Hyperterminal, Etc) and I h...

Hi folks, imagine from a router name 'NAP', I do 'show ip route CRA' and I see the routing table info right there to CRA. Then I attempt to ping CRA and it times out. If I go to CRA, I can ping NAP successfully. I know already that if I do redistribu...

Hi People,I have a router which has 2 ISP connections into it. I have configured an IP SLA to ping an address out the primary ISP interface and install a default route when reachability is up.The problem is, the reachability status is up, the IP SLA...

Hi,At home I have a Cisco 877W and want to calculate how much we download a month as my ISP can't and I want to see if I can reduce my tariff.At work I use Netflow on a server as it is always on, I thouht about using netflow on my laptop, but I'm not...

We have 2 ASA 5540's in active passive failover connected to one of our ISPs. We have other firewalls that have another ISP as their gateway. We want to consolidate and run both ISPs on the ASA 5540s. What I want to do is use the IP address' from the...

I have received the above mentioned error message on the ASR1000-SIP10. What is the error and how it can be rectified? Kindly note that it was the first time I had started the box and haven't configured anything on it.The completely Error Message as ...

hi alli have a ideal, my company has 4 main sites run ospf, and many sites (Dealer)also run ospf. there are in one OSPF domain, area 0. I want filter some routes from main site to Dealers (this mean the Dealer only know one network in the main site. ...

If my serial interface is showing that the:txload :48/255rxload :247/255What would be the average result from this 2 ?Or the end result if i want to know what the utilization from the serial connection that connects to a DS3 .Thank youVic

Basically, the way I read the difference between these two is:dWRED moves drop probability into the router WAN interface queueing decision process, where CBWFQ simply states a BW reservation for the entire class and drop probability is striclty handl...