Routing

Hi All,I have configured MPLS QoS in a 1841 PE router. F0/1, which is connected to CE, is marking the traffic; F0/0 is doing LLQ. But 'show policy-map int f0/0' shows packets matched but no marking is done for 'mpls experimental topmost X'. So I add ...

I have configured eigrp between 2 routers.rt#1network 10.10.10.0network 172.16.1.0no auto summaryrt#2network 20.20.20.0network 172.16.1.0no auto summarywhen i do show ip route on both the routers. It gives the following output,rt1# 10.0.0.0/8 is ...

i am using the below formula suggestes by cisco for calculating policing parameters like bc,beCIR in bpsbc=(CIR)/8 * 1.5be=bc*2So the above formula we are following it for 1G interfaceswe are seeing the maximum allowed bc bytes as below <1000-5120000...

I am getting this message in the log every 5 min "RTR responder null keyPtr, id= 1" The error message decoder says not found. Any ideas what this is?

Hi all,I have loaded the "s72033-boot-mz.122-33.SXI.bin" file in the 64MB bootflash of Sup720. I also specified the bootvar to boot it from this location and file via boot command. However, every Sup720 reboot returns to ROMMON mode. Why is that? ...

I'll be deploying this solution:1 ASA that terminates VPN from a few remote sites1 2821 with two ADSL Annex M (SDSL) WIC'sWhen both Internet Accesses are working, i want to send all vpn traffic through one of them, and the internet traffic to the oth...

Further to the below mail, another thing that was observed is as follows: The ACLXX is used for dynamic nat. This includes only some IP's. Any ip that does not match this acl will not get natted. When u inlcude a permit any statement in the acl, all ...

I've got a Catalyst 3500 XL Series switch and I need to get into it to reset the password. The mode button is broken. Is there a command I can send through hyperterminal to achieve the same effect and reach the switch: prompt?

I have a Cisco 2620xm router connected to DSL Modem (waiting for WIC-1ADSL card)......configured for DynDNS.DynDNS is configured with the following:mydomainname.netexchsvr.mydomainname.netftp.mydomainname.netftp1.mydomainname.netns1.mydomainname.nets...

guys in bgp we can check that what routes our router is advertising to the other peer (keeping in mind we cant logon to other peer) is there any way we can check the routes in rip and eigrp????

Hi,I have a Cisco 1700 series router and a PIX 506 configured on the network. Both devices have interfaces directly connected to the LAN and WAN. Although I would like to configure the PIX as the default gateway I am unable to due to the fact that th...