I created a new vlan and named it VLan300 in our config Vlan100 is the only vlan that currently has access to internet vlan200 does not by and we don't want it to. Vlan 300 will be on a 192.168.x.x network vlan100 is on a 10.76.x.x and vlan200 172.16...
Forum Posts
Could anyone point me in the right direction for researching this issue?
I just purchased four brand new ISR4221 routers as part of an Academy lab set up. I can get them to boot fine, can enter user exec mode and privileged exec mode. However, when I try and enter global configuration mode, I get a command not supported e...
Resolved! VRF
Hi every one i make this topology i can ping from both ISP R1 and from R1 can ping every where, here my question from both PC i can ping only this ip address 172.16.0.0/24 and 172.16.1.0/24 i can't ping ISP ip add. this one my topologyconfig on ISP1i...
I have a L2VPN provided by a service provider from Branch A to Branch B. I was provided same VLAN ID 1137 to tag on my interface ron the two switches. At branch A, I’m using Cisco 3750g and Branch B I’m using a Netgear 4300 switch. I have configured ...
Resolved! VRF VLAN members
Hello,Can a VLAN be a member of two VRFs on 7010? if so, why would be set up to be on two different VRF? Thanks
To the BGP Gurus,I may be "flogging a dead horse" here but here goes........:High Level Summary:===============Are there any gloabl BGP neighbours cmds (i.e. NOT under VPNV4 or IPV4 address-family functionality) to perform a "AS-override" function?Th...
Hi All,I have a Cisco ISR c1117 router at home that I use to replace the standard sky router. I had setup everything and it was working perfectly fine, I also upgraded the iOS-xe and had full connectivity until I came back from holiday.I've plugged i...
Hi Cisco eXPerts. I'm having an issue with a GRE tunnel on the Cisco NCS-5502-SE router running the IOS-XR 7.3.2 64 bits. This is my scenario [server-a] ==> [core-router-1] === GRE tunnel ===== [ internet ] ===== GRE === [edge router] <== [server-b] ...
so we have cisco 1841 that has a PPPoE connection to the ISP. what we want is that this router act as dumb bridge router while handling the PPPoE connectionwe want to connect a fortigate firewall behind it and that the 1841 act as a transparent bridg...
Hi I'm looking for a similar command that i used on nexus7k (routing-context vrf) in asr9k (IOS XR). I used this to test connectivity from a specific vrf.
Hello!I'm a networking Student and I've recently made bounds and leaps in my HomeLab (trivial to some of you but huge to me).I'm running into one issue that my hours of Youtube and Googling I have not been able to come up with an answer. Here is a To...
Is it possible to use LACP and NAT over Layer3 port-channel?Cisco 4351
hi, i got a cisco 4K router with IOS-XE 17.3 and have voice and sec K9 license bundled. we still use "smart" transport and don't use "CSLU" transport method in our smart license. my question is, is the smart license via CSLU mandatory? i can see the ...
Hello Expertsmy question is a little different, i used to use SSH connection to access router with normal behavior, but yesterday i can`t login usually by ssh connection and i get error message (Router refused connection ) so i access by telnet and a...
