Routing

Please, how can I check the PFC utilization on SUP720 ?Thanks,Cleber

Please find the attachment for the network diagram. MSAN is connected to the layer 2 access switch SW3. SW3 has two uplinks, one goes to SW1 and other goes to SW2. SW1 has the uplink to one of the PE and SW2 has the uplink to other PE. MSAN provides ...

Dear team, I am not able to commission 2mb mpls link on Channelized E1/PRI port. i tried with config arecontroller e1 3/0channel group 0 timeslot 0-30------interface serial 3/0:15ip address x.x.x.xencapsulation pppthis is the configuration i made on ...

Hai, Iam having a network cloud which contains the protocols like ospf ,ibgp ,eigrp,rip are running in all routers and the routers are in the mesh connection.So my question is which all databases it conatains like ospf topology table,ospf neighbor...

Hello All!I have VPN aplication a that need access from outside to inside by IP (not tcp or udp) protocol 250.Another words all trafic that have been received on outside interface protocol 250 need be forwarded to inside workstation.If I use static o...

hi,i have 3845 router having E1 link with me SP.i use this E1 link for my internet traffic and intranet traffic,some times the traffic destined to internet gets stuck but my intranet traffic shows no problem. after rebooting the router it comes to no...

Can 7206 VXR NPE G2 IOS 12.4 support LACP port channel? If can, how to configure it ?

HiI have the problem with interconnection of the router cisco 2800 with the Fleet 77(inmarsat)by BRI port.The router display error messages that I can not understand.debug isdn error command returns the following error message:*Jan 1 01:10:15.527: ...

I have ONE serial cable which I want to connect to TWO 7600 routers running GLBP for redundancy and load balancing. Will this thing work with a Cisco HWIC in a Cisco Router? See attached document.

Hello everyone,I've got a scenario where we purchased two Cisco 2851 routers and from reading the information below, it says that we will get sub-rate speeds and the Cisco 2800 series routers are not recommended for DS3. We've already bought the rout...

I have been trying to setup logging via tcp on syslog-ng. all the messages come in fine via udp, but when i configure a tcp source, assign it to the syslog-ng target, etc, then configure the router, i don't get any events. i can see the packets com...

Hi everyone,It seems that pppoe termination is not supported on UBR10012 from 12.2.(11)BC3.I can not find any information if this feature is supported in any later ios version.Is there any workaround for termination of PPPoE?Thanks

Hi , I'm in the need of setting up a configuration with a router which would route packets to two different ISP connections based on protocols,failing to the other active connection should one of the two fail.Can anyone give me help on finding exampl...