Routing

Hi guys,Need some advise from you.My site have a MPLS connection with a CoS service-policy output configure on it. The problem is, my link keep on congested by incoming default traffic! How do I stop this? My business class CoS is base on IP range, d...

Hello All,I am in the process of designing an Extranet and am trying to figure out what are the best practices for such a design in general.In particular is there any standard practice regarding allowing public ip addressing space into the Campus Cor...

Hi,I am trying to build up the given topology by 1760 router and VWIC-1MFT card for voice and data communication. Please give me some configuration level guideline. If possible, Please let me know the required IOS version and DSP module.Here the topo...

Hi, My question is with regards to the usage of the ip accouting command. The Cisco doc says that 'Only transit IP traffic is measured and only on an outbound basis ' ....[1] When I do the below command, it looks like the 'rx' is high but if I do en...

our head engineer is implimenting MPLS across our network..As I am totally unfamiliar with it..Is this much more difficult to support? Im trying to learn about it and basically..they are packets that are tagged..and it is easier to impliment QoS...is...

HiCan anyone send me good documents of Datacenter design including configuration. I am have some doubt in Access to distribution setup..-V

Hi Everyone, I'm trying to configure a 1841 Router to do a translate between one central running X.25 (EWSD) and a client running TCP/IP. The PVCs between the central and the router are ok, but when i try to telnet the central i don't receive and res...

Can anyone make suggestion on which kit to buy from ciscokits.com? I've read product descriptions and they say "this contains the latest..." or something of the sort, but there aren't any dates as to when this information was posted.

Hello,I just had my first MPLS Circuit turned on. I can ping the other side (router) with no issues. But when I setup routing to go to a server on the other side I cannot get to it.Here's what I have on my router:show ip route: 10.0.0.0/8 is va...

Is there either a wic that provides dual dsu-t1 connections or another expansion module that would allow me to multilink 3 T1's on a 2621 platform?

I cannot find any info on CISCO's site if the 4900 series of switch can utilize the MTRJ/SC cable.Does anyone know?

I have a router 2811.I must have an IOS which recognize two-hwic modules and the track rtr.With the (C2800NM-IPBASE-M), Version 12.4(15)T. I have the two hwic modules, but not the track rtr.With IPEntrepriseBASE- Version 12.4(19) and IPADVANCED Versi...

Hi,I have a Cisco 877 where I really need to log everything to a syslog server. what commands do I need?I want to log:wr memsany rules added/changes to config basicallySSH/Telnet accessIPSec/ISAKMP activity for the VPNAny DeniesSome of my rules I ha...

Is there a command to view a PVC that has been built by a provider (AT&T) on the HUB side ATM Router? do not know if this is possible, but wanted some advice..