Routing

Is there away to shutdown an interface if it recevies a prediscibed amount of errors per secound?

greetings!!!i would like to raise this question with regards to ip nat translation, let say i have a 2000 users using a private ip's and a public ip of /24 question is how many ip from public to translate the 2000 users using a private ip.

1.In Router & Switch how can i find out SNMP Community string's version & it's permission(Read/Write)?

how to configure G703 ethernet interface ,in background of this many different locations are connected with one G703 interface, Kindly advice.

Hello everyone,Try to setup two VLNANs, one 192.168.2.0/24 goes out for internet service, and 10.76.10/24 goes fro crypto map via site to site tunnel. Please help to verify the configuration:! !crypto isakmp policy 10 encr 3des authentication pre-sha...

what "return route" mean? my colleague is asking me what is the return route between points. is this the same as "sh ip route"? thanks....

Hi,Hi guys i am facing problem in one of my router , i was trying to get the sh tech support for that router, i am getting following sh tech support format , i have seen first time can any body tell me wht is the problem and when i am getting such ty...

I blew away the factory config that came with my 871w router. now i can not use my sdm disk because it is looking for the 10.10.10.1 ip scheme. can anyone please provide this config so i can start using my router?

I have 2 links (one primary) with eigrp and another one (backup) that I have to use BGP.Can anyone tell where can I find some info in order to configure this so the router will use BGP when the eigrp is down...Regards and thanks

So here is my question.I have Two 2621 routers, and One 3640 router. I have a total of three locations. Where the 3640 is thats how the users get the internet. and the others just branch. We have put in 100mb metroE so that way all of the location...

Can any one Please asssit :I've got a POS link on a 7609 Flexwan Module connecting via a Sonet Network connecting to a remote 12410 GSR.Problem is: i have configured both ends to clock from Line but the OSR keeps reverting back to internal.with the s...