Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Resolved! SH ATM PVC output

HI,I am trying to understand some of the Show command outputs on my ATM routers. Does anyone knwow what the following counters mean? SH ATM PVC has the following counters: OAM cells received: 568647, F4 InAIS: 568647 and F5 OutRDI: 568647As I am ge...

m.lemieux by Level 1
  • 572 Views
  • 2 replies
  • 0 Helpful votes

Hi,static NAT to third party is applied on PIX. One NAT is working fine another is not working now before it was. I compared the ACL with the working one both are same. It seems the second NAT is not being active. Please advise me how can I fix this ...

I was looking over a router config when I ran across the following:ip as-path access-list 17 permit ^[0-9]+$ip as-path access-list 17 permit ^$what is the meaning of this I tried looking it up but maybe I'm not understanding what I read....sorry for ...

wgranada1 by Level 1
  • 3705 Views
  • 4 replies
  • 0 Helpful votes

I know load balancing is a huge issue with BGP, however I figure there has got to be a solution to this 'real world' situation that I am seeing. We run BGP both to advertise our networks and to provide redundancy over our multi-homed network (Call it...

Can someone explain to me (or point me to a reference) what the extendable option does in an ip nat command? For example:<b>ip nat inside source static tcp local-ip port global-ip port extendable</b>The doumentation says:extendable : "(Optional) Ext...

Hello, please help me to slove the problem with the routing cisco 3825. i.e. there are two Internet Service Providers. I am downloading data from the First ISP, but First ISP gone unaccessible, so I want that my transfer wouldn't stop and continue us...

giedriusv by Level 1
  • 350 Views
  • 1 replies
  • 0 Helpful votes

i have a etherdrop between two routers.one interface is fastethernet and other is gigabitethernet . i tried to hardcore the duplex setting and speed 100 but as it is taking only half-duplex due to which i am getting collisions and output drops. Outpu...

Hi Gurus,We have a requirement for running Voice through the corporate network. We have a 20 Mbps link and are planning to dedicate 1 Mbps traffic for voice and voice signalling. Can anyone please help me with the config or any URL's please. We are n...

saimbt by Level 1
  • 397 Views
  • 2 replies
  • 0 Helpful votes

I currently have a problem where I have two routers setup on the same segment. One router is a in country Frame Relay network connection into it and the other is running a VPN encyrpted Tunnel over a public ADSL connection.I am having a issue trying ...

mkmead by Level 4
  • 1056 Views
  • 6 replies
  • 0 Helpful votes

I have a requirement to load balance 2 internet links to the same provider. what is the better option? multipath or multi-hop BGP (using loopback to peer). beside using single peer and multipeer what would be the advantage and dis-advantage of using ...

Hi.As I am a complete beginner at configuring BGP and have the following question. Can you reduce the number of routes you receive on a router from another router that is in the same AS but connected to another ISP?All the examples I have seen deal w...

Kindly Suggest model for below mentioned product.Technical Specification 24 Port SwitchesPhysical Interfaces? 24 ports Fast Ethernet RJ45 Full Duplex with optional PoE support and optional K.21Protection with Two SX GBIC Multi Mode Module fitted.? 2 ...