I've one cisco 2621XM with 125952K/5120K of Ram and 49152K of Flash and IOS c2600-is-mz.122-15.T13. It has one wic-2t and 4 Bri for backup and its serial port is connected to one leased line. Since we're experiencing some randomic errors and bounce a...
Dear All,I would like to know about CE500 have CLI or not? if have please let me know.Now i can use web interface, so i can't setup trunking port?Best Regards,Join
Hi all,We need check if the packets leaving our 3750 in a specific port are actually marked with EF. But we can't use a sniffer. Any idea? I've been trying some "sh mls qos" but the outputs don't show anything...thanks in advance,
hello dear networkers;I have two routers and a wireles link between them.the wireless APs are L2 devices. they have four queue for QOS.so,I mark the packets from my router with COS to make qos.I have three class of users..GOLD,SILVER,BRONZEso i mark ...
I'm installing 2 T1 WICs w/ 2 ports each. I'm going to use 3 of the ports each with it's own T1 card. At the same time I'm going to drop the existing serial DS3 module in favor of these T1 WICs. So if this is the config. of the serial:interface Seria...
I have a 2811 with one HWIC-1ADSL running on 12.4(11)T. The internet on this router keeps stoping. When it happens, the CD and OK leds on the router are solid green and the "show interface" command shows the interface and the line protocol up but no ...
HelloI am a CCNA. I want to get information about Is there any kind of certification of IPv6.If so kindly informed me about this.Thanx in advanceFrm: Athar
The command ip subnet-zero allows the zero subnet to be used on a Cisco router. Does it also allow the all 1s subnet to be used ? Normally the number of available subnets is (2^n) - 2, where n is number of subnet bits. The two which are normally excl...
Darn. I am currently running image c2600-ipbase-mz.123-13.bin and I see that one doesn't support IPSec.Then I used the Feature Set Tool in order to browse, but so far I've seen images which would run with minimum 96/32M minimum.If you know an IPSec i...
Hello, I have a quick question. I have 7206 router in Production. Currently i have 2 FastEthernet interfaces. But if i wanted to use the Secondary addresses on these interfaces. How many secondary addresses i can have. ??? I have got ibgp/bgp and o...
Hello. I need help.I have a cluster running windows 2003 server which are in a Catalyst 3560G and belong to VLAN named "servers".The Network Load Balancing cluster hosts are connected to the Ethernet switch (3560G)which is connected to a centralized ...
Hi,We setup a radius server for authentication. R1 is Internet gateway, R2 is behind the internet gateway with internal segment (192.168.x.x). We can use the radius toauth for R2. It means that we can telnet the R2 and using radius account to login t...
