Routing

Hi there,We have one site in Scotland, where 2800 router with X.21 NTU is connected throught a leased line to a site in Bangladesh that also uses 2800 router, but with V.35 NTU. The loopback test is working fine, but we cannot establish a proper con...

I have a Cisco 877 and 837 in VPN modes and I am trying to them to forward traffic info to a Netflow server, but nothing shows on the Netflow Analyzer website. I have added the follow;router#configure terminalrouter(config)#interface Ethernet 0route...

if office Bravo has network of10.1.0.0/16and office Cindyhas network of 10.2.0.0/24routed together via 2 routers for the two offices.A) what is the maximum number of machine can office cindy and bravo?B)asssuming both machine running on linux.write d...

Hi, I am wanting to allow active FTP traffic to pass through my router, however, I am not too sure how to do this. An access list wouldn't quite work seeing as though the port on the client side is random.My other thought was to use ip insepct's FTP ...

By using the "overload" clause, PAT is possible for inside source NATs. I'm looking for a possibility to do a n-to-1 mapping for outside source NAT too in oder to save IP addresses.Does anyone have an idea? Interchanging roles of inside and outside i...

Dear all,i have a cisco 1841 router and i installed 2 bri module in it and configured that router my NT box is unable to dail automatically . when i keep phone instrumnets to NT box and dail a number its port is coming to active and when i test a cal...

I am trying to upgrade IOS of Cisco 3845 router.But after upgrading IOS from c3845-ipbase-mz.124-3b to c3845-spservicesk9-mz.124-17 it gives error when reload "fail to access file c3845-spservicesk9-mz.124-17" and boot with old IOS.Router have suffic...

I am trying to determine the source of traffic across a DS3 link. I have applied an access-list inbound on the serial interface as shown: access-list 102 permit tcp any any range 1 65535 log access-list 102 permit udp any any range 1 65535 log access...

I'm wondering how many VPN-VPN tunnels can be supported on a Cisco 1711 router? I've one office that connects to another via the 1711 via VPN. I've got another office that wants to connect as well via VPN. Is there a limit in the 1711 as far as numbe...

I have a 7206 Router with 4 FA interface, 3 of which is connected to my ISP Routers, and port fa4/0 is connected to a layer 2 switch going to my LAN.I have configure the router with PBR and trunking to support my multiple subnets with in my LAN.NAT i...

Dears,I have configured my switch 3560 but I cannot ping it?.. this switch has many connected devices for it and all of them I can ping it, it is strange.I connected a camera and camera also I cannot ping it, below my SW configuration.SW3650#sh runB...

I have four VLANs namely:VLAN_ID VLAN_NAME SUBNET10 Finance 10.10.10.020 HR 10.10.20.030 Corporate 10.10.30.040 Servers 10.10.40.0how do ensure that PCs on VLAN 10 get ip address 10.10.10.0 - 10.10.10.254 rang...

I posted this under LAN as well, but didn't get a response. Maybe someone here can help me out:I have a 4948 switch w/L-3 software. Am using VRFs to segment the traffic for two different entities. Am having problems getting the router management stuf...