Routing

Hi Everyone,We have a setup on an ASA with two ipsec tunnels. One to Site A (10.0.1.x) and one to Site B (10.0.2.x), incidentally Head office where the ASA is located is 10.0.0.x, we now need to set it up so that Site A can communicate with Site B. ...

HelloI Need Link includs site to site Vpn Cscenarion/configuration.I Want to do a VPN Test.10xs

HiCan someone please point me in the right direction for the following scenario.We have a primary link into a BT MPLS cloud. At a branch site we have a router with the branch network on one I/F and a DR LAN on a second I/F(this is a mirror of the pri...

Hello group,I have a question regarding Frame Relay Multilink over PPP vs Frame Relay Multilink. I have bundled 4x2MB links into a Frame Relay multilink bundle, but I am experiencing lost fragments on one of the bundle links. I wonder if implementing...

Hi guys,Need to know. Can IOS Version 12.1.27(b), do GRE tunnel??? Where can I get, all the information regarding the IOS capability?

I have an NM-2E2W inserted into slot 0 in a 3620. When I run a 'show int', no interfaces are seen. I ran a show diag...show diagSlot 0: Fast-ethernet port adapter, 0 ports Port adapter is disabled Port adapter insertion time u...

guys, M having problem with my SDM v2.3.1.when i tried to monitor SERIAL interfaces (WIC's) in my SDM interfacse status, than it shows the error: i.e WIC slot 0 is not unrecognised by SDM.If nay one have any idea about the same error dan buzz me up.I...

Hi, I have a question with OSPF based on the attachment that I have posted.1) Since there are 2 routers R1 and R4 that are connected to area 0, would this cause routes to enter via one router and come back to area 1 via another router ? Do...

I have one Cisco 7600 connected to others Juniper's (M20) routers in this fashion: Cisco 7600 (PE) <----> Juniper M20 (P) <---> Juniper M20 (PE)My 7600 have SUP720-3BXL and IOS version 12.2(18)SXF7. I don't have problem when MPLS-TE tunnel between Ci...

Hi,I am having issue with one of my switch to sync with ntp server.all other switches has been configured same and working fine except this, any idea ?Regards,Debug result.Jul 4 13:33:02 BST: NTP: xmit packet to 10.194.255.2:.Jul 4 13:33:02 BST: ...

Hi all,My question relates to QoS.We do not use Voice or Video on the data network, however, I would like to classify our many existing data applications (around 500) into 4 QoS classes, these being Interactive and Transactional (http, telnet etc), B...

Hi,I am wondering how much is the average BW utilizization when OSPF and EIGRP multicast routing updates are happening?Regards,Haitham

Dear All,Im using Cisco 2821 with Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(7a), RELEASE SOFTWARE (fc3)With System image file is "flash:c2800nm-advipservicesk9-mz.124-7a.bin"I want to Configure router with ATM Interf...

IP addresses may not be configured on L2 links.