Routing

Hi all,I got a problem with a Cisco 1841. This router has 2 modules with 4 analog modems. The modems are connected to the telephone line wich are working fine.To this router I connect in case of a backup with 4 external analog modems connected to a c...

I have a cisco 2600 router with BGP configured for two leased circuits of 2mbps from two different ISP's.My Fa0/0 interface sometimes goes down and when i login through the other int. fa0/1 and run shut command on fa0/0 to bring it up the telnet sess...

Is split horizon by default enabled on all broadcast interfaces and nbma(sub)interfaces except frame relay ip physical interface?

hi there CPU utilisation of 3660 is high attached "sho ver" and cpu utilisation details .. any suggetion would be helpful.Trble Sht from my end is , in f0/0 braodcasts are too high, increasing in the rate of 70/secLot of ACLs are confifured for QOS...

What type of G703 interface cables are needed in India, China and Pakistan for E1. There are two types available - CAB-E1-RJ45BNC and CAB-E1-RJ45TWIN. Do I really need one of these cables?

We purchased a company that happens to have the same addressing as another one of our sites. Rather than renumbering one of the locations, we want to setup NAT translations on their router.Can I static NAT their entire Class to to another one with on...

I've been using RME 3.3 to manage my configurations on my routers. Recently, I've upgraded 10 of my routers to 12.4(12). Since doing this, these routers no longer appear as 3662s, 3745s, and 3640s. Instead, they now appear as "Generic Class".Is th...

Customer requests netflow to be configured on a POS i/f on a 7304. The "ip route-cache flow" command has been remapped to the "ip flow ingress" command. Can netflow be configured in both directions on the interface by adding the "ip flow egress" comm...

Hi, is ther any command in cisco routers to find the bandwidth over serial interface with out any third pary tool

Please, could you help to know what would be the low cisco router (cheapest) that can be configured under BPG protocol (8xx, 17xx...)Thanks a lot from Spain,Andrew

what show commands would you use to check the state of an ATM link on a cisco 2621?

Hi,I need to implement ISDN redundancy in the following scenario.I have a Edge Router which has a BRI interface. The router gets Routes from the Core Router where the Servers are kept which would be accessed from the people located behind the Edge Ro...

hey,I've got a cisco 876w with the IOS 12.4-4 T6 but I can't use the ipv6 commands. what's wrong? - will I need another ISO version?in thankssebastian

Hi i have to configure a ILL of Bandwidth 512(1:4) so please help me on how to go about it.The router is Cisco 1841 with one WIC.What protocol should be used.