Routing

We have a pair of 3725 routers that had been working fine until a power outage. Now one of the routers lost its configuration data and we are having problems restoring it to its old state.No matter what we do we always get "line protocol down" on bot...

Algun comando o parametro para realizar Balanceo de Carga en los cisco 1800 con dos interfaces Fa.

Hi,I'd appreciate it if someone can give me a description on how to setup two AS5350s for load distribution of analog modem inbound calls and automatic failover in case one of them fails. Thanks in advance.

HelloI have two routers connected back to back...im running eBGP between them...i want to do redist static (to enter the serial interface networks into BGP without using the network statement, however when i do this i do not see the routes...any idea...

I have a problem configuring Route-Reflector in the following scenario.Diagram:R1-AS100 === R2-AS200 --- R3-AS200 --- R4-AS200 --- R5-AS200 --- R6-AS200 === R7-AS300Legend (for diag above):R1-AS100 --> Router 1; BGP AS100=== --> eBGP peer--- --> iBGP...

I had someone show me a configuration for a 3550 which they set up for QoS'ing voice traffic. The QoS config looks all wrong to me, but I want to make sure I have my facts straight before I say anything. I apologize for not having config samples to...

Hi,,How can we detect that our Gatway router or Core router is under DOS attack....and what should be the frist step ater the detection of DOS attack...Thanks.

Dear all,May i know how to disable onboard ISDN BRI0 S/T. This is because i add in another ISDN BRI module in WIC slot. The purpose of adding in another isdn module because the onboard ISDN BRI port doesn't work which previously was working fine.Than...

we configured cisco hierarchy with core,distribution and access.all 3 layers have cisco 6500 series switches.vlans are configured at distribution switches.i can telnet to core and distribution switches but i cant telnet to access layer switch?..i hav...

hi to ALL,need to do one of technical mechanism (dual stack)and test the Quality of Service and the perfomancehow can test it ?

Does anybody knows how to get the IOS matrix for the CISCO 1720. That will include all the version and memory requirements.

Dear All,i have a problem where suddenly the router failed and when i connected to its console port i logged the attached output. Also below is the last show version taken before the failure (1 week ago).I need help to resolve this problem,Thanks..--...

Hello,I want to implement the CAR method, but I don?t understand a lot the different parameters of the command, especially what is the utility and the difference between burst-normal and burst-max, and how to choose these values. thanks a lot

Hello,I have an Network with some AP 1200. Using the Cisco-Client-Adapters, 350,352,.., DHCP works!If I use any other Vendor ( like On-Board-Adapters ),I have to change the IP Address to static, then it works.Is there any Parameter, i should know?