Routing

Hi there! I will very much appreciate it if someone can tell me the meaning of "bursty traffic". I've come across this term but none of the books I have or other resources I've used explain this term clearly. I'd appreciate it very much if someone ca...

Hi everybody:I have a tunnel between two routers, my routing protocol is EIGRP.I have a problem, the EIGRP session between the routers goes down everytime it detects a EIGRP change in my network.Do you have any recommendation to stop the EIGRP goes d...

I hope someone can please help here. Have Cisco 3845 connecting remote sites using PPP serial connections, routing IPX and IP. Some far ends are Cabletron SSRs, some Cisco 17xx. IP works great. All IPX servers and routes show on all the devices. ...

Our telco Nuvox currently installed the IAD2431-FXS16 because we have a Nortel with some FXO ports. We now have another PBX that has a T1 interface only. How to connect to the IAD2431. s adding the VWIC-2MFT-T1 with a new IOS sufficient? Can we still...

i would like to do end to end keepalive config on 878 g.shdsl router like Frame relay,in this case i try to do a back up configuration with sub interface but our remote 878 router has alredy configured with under the physical interface ATM0.what can ...

HiI want to test my router Serial interface that these are ok or not for this i need DB60 to Db60 calble part num.Thanks

just wanna know which layer4 protocol ospf and eigrp uses??? and whats the port no....like BGP is TCP based and uses port 179.....so just wanna curious abt ospf and eigrp and if u could tell me abt rip and igrp as well that will make my doubts reall...

Hi Guys,Please help with the following situation I am facing. I am implementing dial-up back up solution for DSL link. When the DSL link is down, the backup line comes up, meaning line protocol is up and traffic up to the router.The issue is the dyna...

I have two routers,connecing with a link.router A sent traffic to router B,Router B have three ports.I configure pbr and acl on router B,the port B/1 recevie trffice from A, if the traffic match the acl 'TSAP_USERS',the pbr on the port B/1 will set t...

I have a hard time to understand the theory to configure the backplane interfaces on CMM-6T1 and SUP32. Here is the picture looks like:- Sup32 is in slot 5 of 6509- CMM-6T1 is in slot 1 of the same 6509- Saw the output when show cdp nei on sup32: G1...

The problem is using a netbios application, sending the data from LAN behind router with specific packets with TCP "PSH" and "ACK" flags set that are not making to the server behind the another router.

Hi to all.I have big problem.I need configure my cisco 7206VXR IOS Enterprise for work as dsl aggregator PPPoA and send to cpe Ip add sent from RADTAC RADIUS SERVER for each username.I have 3 kind of CPE.1 ONE IP ADDRESS DYNAMIC2 ONE IP ADDRESS STATI...

Hello, I have 3 3750s in a traingle network. I am trying to set up redundant links between the three by using static routes. The only thing I have done to enable routing is "ip routing". I have not enabled a specific protocol such as RIP or OSPF.T...