Routing

Hello I have a scenerio whereinLan--Cisco801-ISDN WAN--Cisco801--Hub-Cisco2503 Router--Leased Circuit WAN--Corporate NetworkI have the above scenerio and I want to access the corporate network from a host on the LAN side of the network, How do I enab...

Hi! I was wondering wether it would be possible to preform standby tracking based on the availability of an other ip address then itself? (and instead of tracking its physical interface)The hardware we're using SUP720BXL, 122-18.SXE1This could be han...

I am a little confused in trying to best configure bandwidth management for our Hub and Spoke DMVPN router network over the WAN. How would one configure a router to best handle traffic flow out a WAN link, where the router 'sees' the network as fast...

I have four modems dialing out to create a multilink. The modems work fine I can keep them up for the longest I have tried is 23 hours. But I can not keep any kind of routing up for more than 10 minutes. I tried EIGRP and am now trying static rout...

Hi,this is my first time with a cisco product.i am installing a cisco 837 and am having a few problems. When trying to set up the router to put in my WAN username and passord to log on to my ISP the router crashes. i take the following steps.-type ad...

I need to enable appletalk routing to a remote campus over a serial multilink. Do I just enable appletalk routing and define the zone? Also what does the cable-range command do? I'm not sure what to enter for the cable range.

Hi,I am having a problem configuring a Cisco 2600 router. The router has 2 ethernet ports and one ADSL WAN port. I have configured the router as a VPN server and when I connect to it over VPN I can ping one of the ethernet ports but not the other. ...

I have a router that I'm monitoring/managing and the tcp-timeout was:ip nat translation tcp-timeout 460I had a complaint from a user that was being disconnected last night about every 7-8 minutes. This happed when they were playing World of Warcraft ...

I am facing a problem regarding routing between iBGP and eBGP.Within my AS i am using iBGP and with my provider EBGP, routes learned via iBGP are not being advertised to my provider by EBGP. My gateway router has all routes in its routing table learn...

Hi;I have a 2691 router with 4 fastethernet and 2 T1 cards. One serial port is my production WAN hosting my GRE/VPN interoffice connections. Two fast ethernet ports are part of my DMZ. fa1/0 is attached to my DMZ switch, and fa1/1 is cnnected to a 25...

What do you guys make of this? Host router with a point to point frame relay subinterface with an IP address of 10.129.16.1 255.255.255.0. The frame relay is up up with LMI traffic being passed. Then you have a remote router with a frame relay p2p...

I have problem in running X25 switching between PVC and SVC. The setup is very similar to Cisco reference document.http://www.cisco.com/en/US/partner/tech/tk713/tk730/technologies_configuration_example09186a0080094a44.shtmlExcept that, when SVC call ...

I am not IT proffessional but I need to set up Cisco 801 ISDN router in order to accept an incoming ISDN connection call. Is it possible to accomplish that with 801 and if it is possible how do I do that?> Thank youOvidiu