Routing

Hi,Am having trouble getting the line protocol up when trying to connect a customer over an ATM link. The customer has a nortel router. Any specific parameters to be configured.Don't have this issue with other customers using Cisco routers.Thanks Imr...

Dear Sir,I procured one Cisco 3620 Router for CCIE R&S Lab.Which IOS should I download from www.cisco.com to support 12.2T and IPV6.Waiting for reply..Thanks/RegardsAtul

Purchased a router module that can handle an extra two wic's. I installed the module and extra wic's but when I consoled in to configure our point to point the router cannot detect the wic cards.

Hi,There is 3660 router in my network providing NAT to my users but this router has been damage, we replaced this one with C7204 with the same configurationsNOTE: All users use my primary & secondary DNS The problem is that all users which have stati...

Please,is it possible to translate public address to plublic address with nat overload?Best regards

Given two sites linked with two WAN connections, can smtp traffic be routed accross one of the links and the other link be used for all other data?Thanks.

We have a customer who has a well specced IP network, they would like to provide transit across there network for a partner company. An MPLS VPN seems to be an ideal way of doing this, however I do not want to impliment LDP end-to-end on all the devi...

Hi All,The scenario is a DMVPN hub and spoke topology running EIGRP between the hub and spoke sites.We are trying to adjust the NHRP holdtime in accordance with EIGRP.We had set NHRP holdtime to 360 seconds.If the serial link goes down,the tunnel int...

i have configured Cisco router 1841 with ethernet 0/1 to be connected to the internet and the ethernet 0/0 to the subnet (Servers), and also configued access-list to permit some ports from the outside to the servers and apply it at the ethernet 0/1 i...

What is the different between these two? In term of pricing, a lot of different. Our purpose is to segmentize the FULL E1(2M) lease line into different rate. Can we use NM-HDV2-1T1 instead of NM-HDV-1E1-30? Please advise

What is the max number of routed interfaces on a 48 port, 3550-EMI? Where is this documented?

I get messages this, “ InCharge Domain : DFM Clear: Router FALSE 172.16.1.17 PerformanceException - System is experiencing Port or Interface performance problems.” all day long from Cisco Works.I have not been able to find anything in technical sup...