Routing

Hello, all,I have two routers that connect to AS200 and receive the same prefixes from both eBGP peers. Also have an iBGP peer between them.When the prefix is received on the iBGP peer, it shows as "not syncronized" and Im sureI have posted this bef...

I am installing a second T1 connection between 2 of my routers. What is the best method to balance traffic between them? Which method gives the least slowness as the router stops using the failed path? Any suggestions would be greatly appreciated....

Hi,Can I use MPPP with a high speed interface along with a slow speed connections. For example, ISDN/PRI and BRI,E1/T1 interface with ISDN Bri, E1/T1 with ISDN PRITIA-amit singh

Good dayPlease can somebody help me with configuration example with rtr protocol.Best regards

In a frame relay network, topology hub and spoke. Some remtote locations (dlci) have VoIP, others not. I apply fragmentation only on dlci´s that must transport VoIP. But the trunk where all the dlci´s are mapped are the same. What happen,then, when t...

Hi,Does anyone know precisely the role of the routing bit in OSPF DB entries?- This routing bit is no defined in the RFC and is CISCO specific.- I have often read that this bit when set, indicates that LSA is selected to RIB and that advertising rout...

Is it possible to use a 2610 to connect to a DS3 circuit? If so what card and what are the caveats to doing so?Thanks, Bob

Hello All,The internet router 2601 is not saving its configuration to ram.NVRAM has been changed and Flash as well.Everytime it is restarted the router looses it config and have to reconfigur it from scratch.What may be wrong with this device?Thanks ...

My sales staff has asked me to research ways of getting 10mb/s connections to customers using either dry copper or T-1 connections. I have looked at mlppp but am getting conflicting stories as to the maximum number of T-1's I can put in one group. ...

I have some routers to be configured for TACACS+ management authorization. What will be the source IP address of the Tacacs requests?- Will it use the loopback address?- or the ip address of one of the route interfaces?- can this be configured?

Hi All,Does IGRP/EIGRP supports equal cost path load-balancing by default upto 4 paths ??? I think We use Variance keyword just to configure the protocols for unequal cost path load balancing. By default what's the behaviour ???Eigrp can loadbalance ...

Hi All,Can we have the primary and secondary IP address of the router interface on the same subnet. Like interface FastEthernet0/0 ip address 192.168.1.2 255.255.255.0 secondary ip address 192.168.1.251 255.255.255.0router#ping 192.168.1.2Type escape...

Hi, I have two VPN links which I wish to do "per connection" load balancing? Is this even possible?If so, how can it be done?______________________VPN link 1 _____|SW -----------LINUX box--------|_____________________VPN link 2 ______Would appreciat...

Hi All, Lan A|Router A|--Internet--|Router B|Lan B Above is my network Diagram, and ip addressing for the dia is as, Note that this is DSL connection i am getting the Wan ip address from ISP. Router A Ethernet : 200.200.1.0/29 Router B Ethernet : 200...