Routing

dear all,is there any way to manage the default route's tag? I setup " ip route 0.0.0.0 0.0.0.0 1.1.1.1 tag 1234"then, "show ip ospf database" shows different value for default route.thanks

FlexWAN module with a PA-2H (2 HSSI) and a PA-4T+ is not recognised by the 6500. it says when u do sh module it says unkown and power down

I have a T1 from a Harris Intraplex multiplexer that I need to route over a high speed wireless link (2Gps). This link has a 3745(w dual GBIC's) on each side.What can I use to integrate this T1 into the router and how to I config it to send the T1 t...

Hi,I am hoping someone else has had the same problems or a possible resolution.I have 2 GRE tunnels terminating on ISP router, their IP ranges routed to the tunnels are Private IP's. I want to translate one of the class C blocks to one public IP and ...

I found that BGP is not support in Cisco 2800 IP Base IOS. However, C2600XM with IP Base support BGP. Anyone know is there any change in the feature of IOS packaging?

Have 2 7206VXR gateways each conected to different ISP via BGP. Getting full routes from ISPs to start - plan to filter later. Migrating from a single ISP via static default, as well as internal static routes. Have OSPF running between gateways as...

I have 2 transit providers. Currently getting full routes from both and everything is working fine. Traffic is flowing in and out of both providers.Tonight to make sure failover works properly i shutdown the bgp session to transit 1. The problem is f...

I recently setup a Multilink bundle with 3 T's between 2 3640 routers. The link is nice and fast, and I am not getting any complaints from the user population. However, I have been wathing the bundle and I noticed that the lost fragments and reord...

i want to apply QoS shaping, i have a question, i need at the remote site to match traffic from IP network staff even when the link congested we can telnet the router, let us say that my IP address 1.1.1.1 and i want at the remote site to match traff...

I need a help in configuring nat.My net 172.29.4.0/24 should be patted with a global ip 82.x.x.x, but when i try to reach 192.168.0.0/24 over a ipsec VPN, i need to avoid nat totally.I readed something about route-map.Some help please.Thx.

Hello, i am trying to enable isis on my 4500s. When i configure the isis net it does not show in the running config nor is it saved when the router reloads. However it is active until the reload occurs as clns neighbors form. Is this normal?

Hi,I have a C7204 router, working in sgbp group, serving L2TP tunnels for the braodband. The router is crashing, with the following message on the console.TLB (Store) Exception ***Access Address = 0x84PC = 0xbfc052c0, Cause = 0x800c, Status Reg = 0x3...

I have a 3745 router with 2 2Mbps leased line from differents ISP. i have also some VPN connection on each leased line.when i use 2 default static routes with 2 ISP, all VPN connection become down.

Are hardware modules in the 3660 hot swappable? I have an NM-2W with a wic-1t module to be inserted into a 3660 hardware platform and I just want to confirm this model supports hot-swapping.

Hi All,One basic question to you about bandwidth utilization measurement of ATM links !!We are using the MRTG to measure bandwidth Utilization of all our WAN links, and in all cases we could see the utilization growing upto 100% in peak time except o...