Routing

Hi thereWhats the actual difference in the 3 versions of Cisco 7301 router, when you consider the feature licenses.What is ment by "broadband aggregation feature"?

i have put up several posts regarding my problem (see below adsl problem) and no one ever answers.this forum is very quiet. i would appreciate if someone could give me an answer to my problem.i found the following bug CSCuk34163. could this be it?by ...

I have a question concerning ethernet ports on my Cisco routers. I am currently studying for my CCNA, and am trying to do a "Hands on Lab" scenario. I'm using the Todd Lammle Fifth Edition study guide. Page 232 if anyone has it. I have 3 Cisco 2500 s...

Hi,We have a 3845 with T3 link, and want to resell 10-20 T1s to customers. We were initially thinking of a bunch of NM-2MFT-T1 dual-T1 cards with NM-2FE-2W network modules, to buy as customer base grows.Is there a better and cheaper to do that, consi...

Hello All:This is kind of a followup of a post I made last week. I have 3 T's that I load balanced using IP CEF on my side ...just needed it outbound. Worked like a charm....load wise. All traffic appears spread evenly across the 3 t's.What I have no...

There are lot of difference between PPP and HDLC which arises lot of questions. The following are some genric diffrences between HDLC and PPP are:HDLC1.It is vendor specific.2.It doesn’t support authentication.3.It supports synchronous network only.4...

hello,we've got an installation at a customer with two sites connected via a 1Mbit/sec serial link using llq for voice priorisation. after having problems with the voice quality and debugging around i a get very interesting output when using the "deb...

Hi,We have two 2621 Routers (R1, R2) connected back to back through Ethernet interface, all our clients should be routed from R1 to R2 with different ip address, so we've created a subinterface for each client on both routers and we have used Policy ...

I have a router 2821 with two interfaces Ethernet connected to two routers ADSL connected to Internet and a card VIC of four ports connected to the Lan I need a configuration type of this case.Some users have to go out to Internet for a connection AD...

This is Nilesh, from India,mumbai. Working as Network Engineer for Birlasunlife Insurance Co.Ltd,Here in my network i got Two 2610 Xm series router, where first rouer is myProduction router and another one is standby.so there are three 2 mbps links o...

Hi,I have configured HSRP on my core switches, Cisco 4006,and is working fine, standby taking the role of active is fine without much delay, but as soon as the active is restored there is a delay in time for the standby to recogonise the active ,pls ...

does anyone know of any step-by-step instructions on how to configure a cisco catalyst 3560 and 3750 switch with VLAN's and also cisco 2800 and 3800 series routers....for both across the wan and the lan?I just want to know what each line by line conf...