Hello All,We have an IR829GW router. I need to use it as a typical old school NAT router such that whatever devices are behind it use a NAT IP for the traffic that's going outbound ( For instance Internet access). I have looked in the config guide ...
Hi Team, Need your help on this. I have configured Router 2951 with sub-ip on GigabitEthernet0/1 for multiple vlans and switch WS-C3750X-48P-L with trunk port and multiple vlans. I can able to access the internet on the default vlan 1(192.168.2.0), ...
Hello Team, i need you kind assistance in solving the 7841 phones not registered with the CME, i am using 4331 router and 2960 Non POE switch. I can see the voice VLAN, TFTP server IP, and ping the phone but the phone still unregistered. i am work...
Hi guys, so I'm new to packet tracer and am trying to learn to set up a multimedia network and I wanna include VoIP in it. I've been trying to figure out how to set up IP phones over a WAN but even after trying to follow all the tutorials I found onl...
This router is missing its IOS and I have been trying to use an external usb drive to load the correct IOS but have been running into this issue where I am getting: fnuhcd5200OpenPipe ERROR opening PIpe CVMX. Any insight would be greatly appreciated...
Hi Like the diagram, is it possible to only form OSPF nei C1 to Fish1 and C2 to Fish1, but not C1 to C2, if I use passive int it will disable the OSPF neighbor to Fish1 as well, if I use OSPF authentication it will still form the OSPF neighbor betwe...
HiOur service provider has configured 3 vrf's on their interface connecting to our network, we have a L3 peering with them and all fine with this, but these new vrf's are L2 not part of any routing so how can I put a Firewall in the path somewhere i...
Please find the attached out of Show Env Power. There are two temperatureHotspot#1 and Hotspot#2 Can any 1 explain What does these both exactly mean?
Hi, I have a Cisco ASR9010 Router running only with one RSP card.Now I want to add another one to have a redundant system, but I want to know what happens if the card that I will add has a newer IOS XR version compared with existing one.Do you have a...
I am having issues loading the IOS on my 2821 cisco router.
Hello Experts, Just want to know is it possible to establish tunnel from MAINOFFICE ASA(in diagram) to SITE1 ASA & SITE2 router. I know both wont be established at same time. But what if MAINOFFICE ASA tunnel has been established with SITE1 and traff...
We had a NCS 55A2 reboot due to power loss in a lab. Now it is showing this prompt: xr-vm_node0_0_CPU0:/ Anyone know how to get back to running from this point?
I have a WICT2 card installed on a Cisco 2911 router. When I run show inventory the router sees the card. When I try to configure the WICT2 card I receive this error:Router#config tEnter configuration commands, one per line. End with CNTL/Z.Router(co...
Hello all,I am having a problem with my 1941 router sys led is showing constant orange light and I can't access the CLI and I checked the fan is working and it switches off and on automatically. Please I need help on this.
HiResearching about ASR1013 I have some Questions:1- If we install ESP200 + 4xSIP40 then what will be the bandwidth per slot and Capacity of Inter-slot Fabric?2- Does ESP200 provides the Fabric Bandwidth in this router?3- Regarding Question#1, Will w...
