Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Hi all, I have a Cisco 2960 switch running IOS 15.2(7) E7. I configured NAT overload.Straight forward config:interface Vlan150description INSIDE-LANip address 10.150.0.254 255.255.255.0ip nat inside!interface Vlan192description OUTSIDE-LANip address ...

Hi,   I have a scenario were i have to implement a solution which allows for dual ISP redundancy on spoke into dual hubs in a dmvpn environment.   I have created two tunnel interfaces, both have tunnel source set at each respective physical interface...

eirikalim by Level 1
  • 1053 Views
  • 9 replies
  • 0 Helpful votes

On a switch-to-switch interface, can we configure both of these commands at the same time, or can we only configure one of them?switchport mode trunkswitchport trunk allowed vlan allinterface GigabitEthernet1/1/3description ****Uplink-Block-Switchswi...

Hello Guys,We are planning to upgrade Cisco router Cisco C8300-1N1S-4T2X from XE image 17.6.5 (Rommon image 17.3(5r)) to latest XE image 17.9.5a. As per Rommon compatibility matrix, this new XE image should have minimum rommon image of 17.3(1r) and m...

Noovi by Level 1
  • 128 Views
  • 5 replies
  • 0 Helpful votes

Hi,we are using the Cisco ASR1001-X as core router on our ISP network. For the management of the CPE I set up a TR-069 ACS server. For testing purposes I configured the ACS URL manually on the CPE, which works fine.However I'd like our ASR to pass th...

andy89 by Level 1
  • 334 Views
  • 10 replies
  • 1 Helpful votes

Hi, I am setting up smart licensing on several L2 and one L3 switch. L2 is working fine, L3 not. It seem that fqdn's can't be resolved.On L3 dns server is set up. There is a transit VLAN between L3 and the firewall. When I specify the source in ping ...

mcgiga by Level 1
  • 134 Views
  • 4 replies
  • 0 Helpful votes

 BST: %IOSXE-2-PLATFORM: R0/0: kernel: EXT2-fs error (device sda1): ext2_lookup: deleted inode referenced: 3170306  BST: %IOSXE-2-PLATFORM: R0/0: kernel: EXT2-fs error (device sda1): ext2_lookup: deleted inode referenced: 3170329  BST: %IOSXE-2-PLATF...

DearsIn our environment we had configured UDP IP SLA probe which gives us the desired results to monitor IP SLA statistics from Source to Destination. But the negative part is, this probe does not tell us in which network hop the latency occurs.I had...

rhari by Level 1
  • 71 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card