hi i have configured Umbrella Secret and key for Umbrella dns integration. DIA is configured for this VPN. i am not able to see SDWAN router on umbrella portal. on c-edge (router 8200 v17.09.03a) sh sdwan umbrella device-registration DEVICE NAME STAT...
Forum Posts
Hi everyone,I’m looking for guidance on configuring SD-WAN to prioritize MPLS as the primary transport link over the internet. I want the internet to act as a secondary/backup option only.Additionally, I have two internet interfaces and would like to...
Hi All, recently I have been trying to setup a Cisco SD-WAN lab on my VMware ESXi server. I have a very basic topology consisting of vManage, vSmart, vBond and few C8000V in controller mode acting as edges. So far I have configured all the controller...
Need to use the SD-WAN C8300 to bridge on the internal network two VLANs together in a CoLo site. I know I can do this if the C8300 is in autonomous mode. Can I do this when in SD-WAN mode? Do I have to create a CLI template to do this?
Hi ThereI am getting the below error :V manage login: FAILED: cdb _connect( CS , ST, ADDR, ADDRLEN, Error: system call failed (24): Connection refused, in function run, line 2401 )this message is appearing after formatting the 100 gb hdbv manage vers...
Hi.I have deployed vManage 20.7.1 on vmware esxi and applied basic configurations. After that I connect to web GUI by my browser and I try to login but it's like an endless loop and after click on login button, login page is loaded again.
Resolved! CG522-E system-ip with vManage template
What IP address should be set as the system-ip address in the vManage template? 1. The IP provided by the wireless sim provider?2. The IP to assign to the ENET interface of the CG522-E? ( for local management )3. The IP to be used on a SD-WAN VPN (...
Hi, Based on picture above, assuming that's cisco SD-WAN in DC. How cisco SD-WAN in DC serve the traffic from sd-wan branch? Will both device in DC be active-active? or only one will serve the traffic from branch? If the answer is active-active, how...
we can make combination between cisco 8200 and 8200L as edge Router in the same sdwan solution
Hello Fellas,I'm new to this community. We deployed an SDWAN in our organization. Our set up was 2 Internet ,1 router edge. We configured NAT(1st Internet) but every time of failover (2nd internet take over) our NAT was working. We want that every t...
Hi. I work at a public library and I want people who use our access points be able to connect to their work VPN's just like they would if they were at a coffee shop or at home. But so far, nobody can. That includes library staff who connect to our...
Hello Community, I recently deployed active/standby set up for single router dual circuit where one circuit has slower speed and was meant to be a backup line incase primary failed. I made following two config changes to make it work and was curious...
Is it possible to specify the OS file located in usb0: for the OS installation when executing the request platform software sdwan software install command, instead of using the OS file in bootflash? If there are any precautions or points to note, ple...
Hi,i lost my username and password for neo4j databasechanged it from default credentials neo4j/password i now i cant remember which is new password.what i can do? only tac can help it?is there any way to find at least the username?Regards,Hugo
Question on TLOC preference. Quick diagram attached.If private1 is set to higher TLOC preference, can it cause issue routing to sites that only have public-internet?For example:R1 should always route traffic across private1 to R3 and vice-versa.R1 sh...
