Switches - Small Business

Hello together, we are using a Linksys SGE 2010 in our small business. I would like to know which devices (MAC-Address) is behind a specific port. Does the switch have this function? I can't type commands, because the SSH or telnet interface is a men...

Any suggestions on best practices for firmware upgrading. Currently using a combination of SF200 switches (SF200-48, SF200-24, SF200-24P, SF200-24FP), WAP561, and WAP321. The question is should I step the updates from the current to the most recent o...

Every time I upgrade to 1.4.0.88 firmware version things quit working in the web interface.  First I noticed DHCP pools would not work.  I then downgraded my firmware version and it started working with the web interface.  After this last upgrade I n...

Hi, I have a Cisco SG200-26 Switch with a ICMP issue so it seems.  I have tried to ping the management interface with no success.  However, I can manage the switch via the web gui which is strange.  It seems that the switch is allowing HTTP/HTTPS tra...

Hello,I have several SG 300-500 switches in our network.  I have started to lock them down in terms of shutting off telnet and http using ssh and ssl for remote management.  I have the current firmware on all the switches in question as of Aug 2014.F...

 I have two SG300-24P (SRW2024P-K9) switches installed and working fine but the system LED on lower left front corner does not come on. Any suggestions for us to get these lights to properly indicate the system is powered up and working?

I support several SG200-26p Small Business switches.  As our networking has grown more complex, I'm now starting to venture beyond basic configurations.With the 200 series switches, is it possible to deny service / turn off a port if an unknown WAP, ...

Hi!Please have a look at the attached pictures, till yesterday everything was working but today inter v-lan routing is not working, I am unable to get the IP addresses from the central switch. Central switch attached with 3 different L2 switches. The...

Hi.  I recently purchased a SG300-10PP and during configuration I noticed a service running on port 40001 and 40002 called "WBAHttp" and "WBAHttps".  These ports are actively listening, but it is not clear what they are listening for. There is no doc...

Hello all, I'm new to the SG series switch. I am used to seeing a lot of output when using the "show arp" command, but on my SG500 I only see one entry. "show mac address-table" shows me all the L2 information, but why can't I see the L3 information ...