Switching

Hi We are planning to purchase some C9300 with a DNA center and everything with the DNA Advantage subscription. I'm not understand if I need a an additional Smartnet contract or not. According to this document I'm getting with the DNA Advantage subsc...

getting unrecognised characters while taking the console. tried changing speed but no hope..  

hi ...trying to get mpls l2 xconnect up between cisco and juniper router but unable to do so. local interface: Gi0/0/0.100 up, line protocol up, Eth VLAN 100 up  Interworking type is Ethernet  Destination address: 2.2.2.2, VC ID: 100, VC status: down...

Hello all,I have already configured a Master Key with the command: key config-key password-encryptWhen I tried to configure cts on an interface, I am not able to insert a type 6 password:int Te1/0/1 cts manual no propagate sgt sap pmk 6 KIv...

Got a strange problem, maybe some of you could help.Dhcp snooping is up and running, database are saved to tftp file, all looks good. Snooping running on one vlan, switch#show ip dhcp snooSwitch DHCP snooping is enabledSwitch DHCP gleaning is disable...

Hi all, i run ios 15.2 version and have a problem to receive on my snmp monitor the interface vlan accounting information.Is there any command that i must configure on global or interface vlan base? Thanks!

My name is ali. I am new in Cisco. Now a days i am studying Cisco Switching by myself. When i watched some videos then i feel some confusions. therefore i need a expert who help me. I will pay him weekly. When i feel confusion i will make a document ...

I'm running into an issue recently after we migrated all our switches from Brocade over to Cisco 3850's.We have Cisco 3850-24XS with GLC-GE-100FX SFP's connected to a media converter then to a workstation and traffic is working fine. At some point th...

I have two 3850's and one of them is not accepting traffic from the other one. Switch 1 (G Pod) - all of the trunk ports on this one are working when connecting to other switches except for the one in H Pod (Switch 2). The other switches that connect...

Hello all! Hoping someone sees this that can help me out! I’m currently studying for my ccent so I’m very new to the Cisco world but I bought a couple of refurbed switches off of eBay for a lab and one of those is the 200 24 smart switch. Much differ...

If in ether channel 1 bit use for 2 link and 2 bits is use for 4 links and 3 bits use for 8 links so tell me how many bits will be use for 3 ,5,6 and 7 links. i do not know how to calculate value for these links or which link will be use for forwardi...