Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...
Forum Posts
What is the commands to copy a router config to a TFTP server?
Resolved! Cannot reset 2960 switch
I cannot reset a Cisco 2960 PoE-24 switch back to factory defaults with the mode button. The switch never goes into reset mode. after the switch completes the power cycle, it just displays access verification with a username and password. The userna...
Hey there,my question is:Is Switches have MAC address? thanks
Resolved! Cisco 3750G wireless controller
Hi all, Recently acquired a Catalyst 3750G 48TS-S. We are planning to use this for it's integrated wireless controller. I ended up getting the firmware updated and was able to get into the express setup, but I don't see any options for configuring t...
Hi, I'm trying to setup my ASA 5510 to allow traffic between two interfaces Ethernet 0/1 Inside 192.168.10.1Ethernet 0/2 PBX 10.21.5.254Both security level is set to 100 and "Enable traffic between two or more interfaces which are configured with sam...
Hi i have a switch cisco and i have a problem, let me explain. I have multiples servers(hosts) connected to the cisco that deliver a stream service so far so good but when i connect physically a new cable or when i make noise in the switch (up/down s...
Hi, I have 2 Nexus C3164Q-40GE switches and currently there is a trunk connection between the 2 switches. I want to have VxLAN config so that it can pass between the 2 NX switches. I read many articles but can't really have an idea how to config VxLA...
I want to test some features for CIsco 891F model, I can find a configuration guide but it has details only about some basic things & about Static & Dynamic Routing. It doesn't cover about SNMP, NTP etc . Can anyone help me in finding the proper con...
Resolved! Switch Licence, quarry
Hi, Model is : WS-C3560X-24T-SLicence is :Index 1 Feature: ipservicesPeriod left: 8 weeks 4 daysLicense Type: EvaluationLicense State: Active, Not in Use, EULA not acceptedLicense Priority: NoneLicense Count: Non-CountedIndex 2 Feature: ipbasePeriod ...
Hello, I am attempting to to configure a setup with the attached configuration. In this config there is a server on vlan 1, two workstations on separate vlans that interface with the server on vlan 1 as well as another system on a separate vlan that ...
Hello, I am working on a unique system & switch configuration where there are middle-man workstations that communicate with each other and a community of servers. Each workstation must also be able to communicate with one single isolated workstation/...
Resolved! Cisco 891F for LAN
Hi i have to had to post this question here because as per usual Cisco's site does not provide a straight answer or any insight as to the performance of the LAN cards on these routers (from what i can find anyway) Just to note i am not concerned abou...
I am new to virtual staking and am not sure what I am missing but any time I enter the command - Switch(config)#stackwise-virtualI get Invalid input detected at marker. Can someone tell me what I am missing?
Resolved! 9300 and 9500 config files
Sorry to have to ask but can someone send the basic config file for a Cisco 9300 and a Cisco 9500.. Doesn't matter how many ports on each. I have to write sample configuration files for each and we have not received the 9300 or 9500 in stock yet. I d...
Hi All, is there any ACE hard limit for VACLs in NExus 7k running NS-OS 6.2b?, if we use more entries is there any performance issues?
