Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Dear Team,   We are facing issue while doing wifi unification eg:   We have AD trust with our Dubai office & india office we have added there end controller IP , as well as radius IP in our radius server with same key including NPS policy, wifi polic...

yogesh1 by Level 1
  • 530 Views
  • 3 replies
  • 0 Helpful votes

Hello,   My clients WS-C2960X-48FPS-L are running LAN-Base license. Do the switches support intervlan routing?   Sample config:    ip routing  interface vlan 100  ip address 192.168.100.1 255.255.255.0   interface vlan 200 ip address 192.168.200.1 25...

  Hello,   I have configured a port security feature on switch port Gi1/0/13 which allows only two mac addresses to be forwarded (See image_1). the switch port is connected to a wireless access point where clients can access to a local network. based...

Hi!   I'm trying to get the good configuration for multicast routing and IGMP. See attached diagram. I have a source in VLAN 25 and clients in VLAN 4, routing throught the C3750X L3 switch, with 2 C2960X switches as L2.  I'm not sure If I got it corr...

Dear Team,   I am new to cisco ASA i need to allow port 80 from LAN IP 10.0.0.0/8 towards source 11.0.0.0/8 how can allow the port source & destination IP.   Also i am able to ping multiple IP from firewall inside interface to outside towards other e...

yogesh1 by Level 1
  • 2432 Views
  • 4 replies
  • 0 Helpful votes

Hello, First time poster, I know a lot of people ask this question about what to get and so on and so forth, But currently I have a new job and am looking to get to a CCNP for routing and switching, in the path of CCENT >CCNA > CCNP.  I have at home ...

Hello All,   We have two running cisco 4510R+E switches as a Core and HSRP is running in between them, earlier we had upgraded the switches IOS with IOS XE 3.8xx release and after upgrading that, everything was good but whenever i am checking logs, s...

Hello,   I am going to be receiving a few 9407s and would like to start preparing base configurations for them.  Is there a way I could get a copy of the factory default configuration as a starting point?  I want to see how they look coming out of th...

Hello, I'm following a few configuration guides to test out a VXLAN deployment using Nexus 9k's in a VIRL environment.  I've got everything working to a point where I see the routes being exchanged between leafs over the spine infrastructure.  Each ...

pdub206 by Level 1
  • 1276 Views
  • 1 replies
  • 0 Helpful votes

Hi pals! I 'm having an issue with my 5596. I'd like to enable web managament portal. At my conf, I have already enable feature  http-server, but the SW is not listeting 80 nor 443 port. Any idea o sug? Thx Mariano

soporteca by Level 1
  • 345 Views
  • 1 replies
  • 0 Helpful votes

When you have a stack of switches in this case layer 3 switches which one in the stack will do all the processing. I assume it would be the active (primary) one and not any real processing on the other switches in the stack? for instance we see the a...