Switching

Hi i am new and preparing the CCNA exam, I just ceated one topology and running the Rip version 2 and Eigrp , When i look the routing table R0 and R3 i seen the Rip learned the 4 routes and Eigrp learned 3 Routes and 2nd question is at both router on...

Is anyone aware what are LEAK maps restrictions in EIGRP? I was looking for some detailed information about it and was not able to find anything I'd like to leak some routes which I've tagged on a different router during redistribution, but as it se...

Hello. I am new to networking. Recently there is a need to add a new vlan to one of the instance in the mst configuration among the switches that run MSTP. And I have searched and read post that there must have some network interruption when configur...

hello,   i would like to use the Fiberport as LAN-Port. Gi0-Gi7 are working well, but Gi8 is not usable. Is this possible or is this port only usable as WAN-Port.   I'm using the ADSL-Port for internet-connection

Hi Team,   I have a cisco isr4431 router running with "isr4400-universalk9.03.13.04.S.154-3.S4-ext.SPA.bin"version where i can observe below error.   %ENVIRONMENTAL-6-NOTICE: V: PEM Out, Location: P0, State: Warning, Reading: 0 mV %ENVIRONMENTAL-6-NO...

What are two requirements for an HSRP group? (Choose two.)A. exactly one active routerB. one or more standby routersC. one or more backup virtual routersD. exactly one standby active routerE. exactly one backup virtual router

is the switchport block multicast command useful on the switch interconnection trunk port?   For my understanding, only the access port need this command to prevent some unknown layer 2 multicast traffic. Will this command create issues if configured...

Hi,   I'm configuring a new WS-C4507 VSS deployment, do I need a special license? How can I verify the current license and if a new one is needed, how can I get and activate it?   Chassis PN: WS-C4507R+EChassisSUP Supervisor PN: 7L-E LANBase License ...

Hi Expert Team,   I have configured "tranport input none" in line aux 0, but I don't see the "transport input none" on AUX 0 in show run. Please help about this problem, my device doesn't pass security compliance  because of this command. DC-RTR-02(c...