I am having some issues with my configuration to where it will not allow my to ping past my Hwic card (ATM 0/0/0). Any help would be greatly appreciated. My show run is attached. Thanks, Allen Router#show run Building configuration... Current...
Forum Posts
HI Team, We are facing issue with C2802i APs at one of our location. The APs goes to hang state and users are unable to connect, but one we reboot the APs the users gets connected. The issue repeats once or twice a month. Although we don't face any ...
Hi, I have 3650switch running 3.7.2E iosixe version where i can observe high cpu due to below process. Fed punjectRx The above two processes are consuming the major portion of the cpu. Can any one explain what is these process and how to prevent th...
Hello everyone I hope someone can help me I just choose a 4507 RE used switch and I inserted a supervisor map Engine 6 THE WS-X45-SUP6 LE but the card reboots loop (continuous reboot ) still even after I give it the Boot command in Rommon mode for bo...
Resolved! 2960X Switch Stacking with fiber
Hi All, I am trying to stack 2960x "WS-C2960X-48LPD-L" switches in two different racks, and racks are far away from each other. ( lets say 4 Meters distance between racks). My ask is, how I can create stack between switches using fiber cable (100...
Hello! When it comes to routing and switching, anything more advanced than one router/switch, and I'm lost. I currently have a FIOS modem/router with hosts connected via ethernet and wirelessly. I've connected one ethernet port to a 1941 router. ...
Hello, I have 3 days searching on the internet and still no information about this. I have bought a Multi Layer Switch 3560 for lab environment and need to upgrade since the exams now operate on IOS 15. Cisco official site: Note that the following mo...
Resolved! Redistribute OSPF E2 routes into EIGRP
My R2 router has OSPF E2 routes learned on its fa0/0 interface. These were learned via OSPF but originated in EIGRP AS 20. My goal is to redistribute them on the R2 fa0/1 interface into EIGRP AS 10. For some reason, it doesn't send these routes to th...
We're having some kind of problem with ARP on Nexus 3548. Here is the topology: topology The Checkpoint is connected via LACP to the two Nexus switches. When the checkpoint FW tries to ARP request the MAC on Nexus 1 (VLAN interface 99), the following...
Unable to set the pxe parameters for WDS PXE boot file name and server .Kindly suggest a working solution.
Hi all,Does CVR-4SFP10G-QSFP adapter create a new single QSFP Ethernet interface, in config CLI ?Can I create a port channel with two QSFP adapter ?I've a 6880 switch.Thank you.
We use our Cisco Catalyst 4500 switch for our DHCP in our environment. We have multiple networks. Would like to PXE boot new machines on network and point them at a WSD server (for an image) that is on another static network that is accessible by t...
I have a route that was working on my external router. On router I had address of 198.215.4.0/26. On this subnet I had several servers that connected to user devices to push updates. Well I virtualized the servers and made the subnet smaller (198....
Resolved! multiply subnets Host unreachable
Dear Reader, I created two networks in packet tracer. I can't figure out what i'm missing in network 2. Network 1 client > switch > router > SIM cloud Network 2 client > switch(configured as router) > router > SIM cloud I'm able to ping the i...
Hello Freinds i have 2911 router licensed with UC/Sec/Data , did IOS backup to TFTP save as well these enabled licenses thanks for more insight about license retains as well thanks
