Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

Hello All,   Can somebody let me know how to calculate througput on cisco 4331 ISR,   We are having currently running with 100 Mbps throughput and link speed is 70 Mbps.   Please let me know it enough for 100 Mbps or i need to upgrade to 300 Mbps

Dear colleagues! Could you share your ideas, about this issue of incompatibility between WS-C3750X-24S and GLC-FE-100LX. According to the compatibility matrix WS-C3750X-24S is compatible with GLC-FE-100LX, starting from 12.2(58)SE1 IOS release. But, ...

Hello,Can any please confirm the C3KX-NM-10G module is hot-swappable.i have checked the cisco's website and it says "Although network modules are hot-swappable, we recommend installing a network module before powering the switch" What steps i need to...

Hello,   I have a question considering if is security wise to allow traffic from a user vlan to pass through a port-channel that is used for management traffic.    Can you describe the pros and cons of doing it or not.    Best Regards John

Here is my config: r3: (dns server) ip dns server ip domain lookup ip host baoshan.com ns ns2ip host ns2 192.168.100.2 ! r4: (dns client) ip domain lookup ip name-server 192.168.34.3 ( which is r3 ip address) ! r4: ping test.baoshan.com r3 didn't for...

xh_liu by Level 1
  • 3340 Views
  • 8 replies
  • 0 Helpful votes

I have a new industrial ethernet IE 1000 Switch.    I am in the classic position of needing to configure the switch to use a non-cisco SFP module.  the switch software is not the classic IOS.  I need to know the equivalent commands to allow the switc...

Hi All, My company want to upgrade IOS for 6509-E VSS with one VS-S720-10G on each chassis. currently it runs with this IOS s72033-ipservicesk9_wan-vz.122-33.SXI1.bin. can i upgrade it to s72033-ipservicesk9_wan-mz.122-33.SXJ10.bin ? thank you

AndreRS by Level 1
  • 664 Views
  • 3 replies
  • 0 Helpful votes

Hi   We have a guest wifi whose SVI terminates on the firewall. I have enabled anyconnect on the inside interface so that I can connect using anyconnect from the inside where the SVI is on a switch.  But I cannot connect if I am on my guest WIFI. So ...

Review Cisco Networking for a $25 gift card