Switching

Hi, I have a question regarding my layer 3 switch. Currently, the network works fine except that the layer 3 switch (which is Curly) cannot ping outside the management VLAN, and other devices cannot ping it. Moe can ping all devices fine. So, my que...

Hello. We have to make the manuals how to install IOS or to input configuration to the Catalyst 4506 machine. And, especially we don't know how many patterns there are about it. ①Supervisor Of course,in this pattern the configuration may be not kept....

Hello I am creating a banner. when i put this command then some options are appear . s1(config)# banner ?   there are some option appear Line Exec incoming MOTD prompt-timeout slipp-ppp Plz tell me if i set banner on these option then where banner w...

Hello I have one user Admin and i have to configure telnet session. Admin can create multiple telnet session at a time. But i want to do, Admin can create only one session at a time.  Please tell me how i can do it. thanks

Hello, I am quite puzzled with the issue I am having. In my test, I had route-leaking setup. Saved the configurations and turned off the router. Next time I boot up the routers, my route-leaking isn't working.  Problem:1) Computer VRF cannot ping any...

Hello, Please tell me, if we configure line vty password then it is not secure. for example. s1(config)# line vty 0 15 s1(config-line)# password 12345 s1(config-line)# login local s1(config-line)# end it is not secure. if we create a user and then en...

Hello! I've spent quite a while on the Internet so far trying to find whether WS-X4548-RJ45V+ Catalyst 4500 PoE+ Ready 10/100/1000, 48-Port (RJ45) switch supports VLAN and how many trunk ports it has. However, no matter where I've looked so far, it o...

So, my IPS is Time Warner and so I have a router, dynamic IP Address I just trying configure my Cisco 2600, which will be connected to a cisco switch 2950 switch and from there, connect PCs to and go online.. Can someone help me please Please find c...