Switching

hi,My objective here is to provide internet to all 8 ports, but i don't want them to comunicate between each other...The solutions i was trying to do here were:1 - assign a diferent vlan to each port. The problem with this is that i can only have one...

Hi i was wondering if anyone can help as we have received the new version of 48 port switch and our normal console cable is not recognised when using hyper terminal for configuration. It still works for the older models both 24 and 48 port set at the...

We have two 3750's running VRRP acting as the first hop routers for three 2960 access layer 2 switches. Would it be possible to extend the VRRP service to two new ESXi 6 servers running VMWare, upon which is configured a virtual switch that supports ...

Hi, I've been unsuccessfully trying to find a cause for this problem, we recently installed a Catalyst 3650 to act as a distribution/core (collapsed) switch and we're having issues with ports going down and up. I'm pasting here the show run, show log...

HI,I am using a WS-3560-48PS with IPBASEK9-M version 12.2(55)SE6.Actually :I have 5 vlan configured with wired LANI have a new 100 Mega  internet acces with french provider connected to the switchModification :I need to install Access Point 1832 on o...

We're implementing a router at a local branch office that's directly connected to our primary data center via two pairs of fiber. I'd like to set up a port-channel from the router to each of our Nexus 7706 chassis using VPC. We do several layer 2 VPC...

I am trying to document/justify all open port on my systems and I am finding all of my IOS Switches are running TCP 10002 show ip socket | include listen 17 ‐‐listen‐‐ 192.168.251.251 123 0 0 1001 0 17(v6) ‐‐listen‐‐ ‐‐any‐‐ 123 0 0 20001 0 17 ‐‐list...

while doing initial configuration for wlc 2504, i felt it was taking so long to do the saving, i then reset by pressing the reseting button, since then i can no longer access the wcl

Hey guys, I would like to know: We have multiple cisco catalyst switches, two Cisco Wireless Controller and multiple Ciso Access Points in our network. Do you put them in one Management vlan? Or are there any security concerns to put cisco switches t...

Hi, Is there any difference between ws-2960x-48FPS-L V02 and ws-2960x-48FPS-L V04, can you stack both? Regards,   Nyi

Hu Guys, i recently replaced my older Router cisco 1800 to a new one of the family  C1900 Software (C1900-UNIVERSALK9-M), Version 15.2(4)M3, i have a template snmp that get (RFC1213-MIB::ipRouteNextHop.10.0.0.98), unfortunately after this router cha...

Hi, I have just received the Cisco 1841 v 05 router and I wanted to know if it was possible to load on this router to my current router's setup, the cisco 1801 v 05. Obviously, on the Cisco 1841 is installed HWIC 1ADSL to use the connection. Is it po...