Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi,I am working with a Cisco Nexus C7010C chassis with 4 VDCs, using the default QoS policy maps, running 6.1(2) and I am trying to view the QoS statistics for particular interfaces. I have run a few show commands which you can see below but I am not...

John5mith by Level 1
  • 787 Views
  • 2 replies
  • 0 Helpful votes

Hi all, I have the requirement to disable the syslog rate-limiting for a special syslog message on Nexus switches. We have a management system, which tracks the syslog-events which occur, when you leave the config mode e.g. 08:46:27.126 SWITCH %VSHD-...

This seems like it should have been an easy fix, yet here I am. Our SNS, which we're using for authentication will randomly stop doing it's job, and users can no longer authenticate. I'm not able to reach the device at all. So upon checking the physi...

I'm a newbie, trying to setup telnet in my home lab to prepare for the CCNA exam. I've set IP on management vlan, set default gateway, configured  VTY lines 0 15, set transport input to all and verified all configurations.  How do I physically connec...

Hi. We have two switches in diffrent buidling connected via fibre. For some reason, the design states that the switches will need to be configured with Lyaer 3 connectivity and redundnuncy. So, at on e end we have the core switch with two interfac...

Bab L by Level 1
  • 571 Views
  • 6 replies
  • 0 Helpful votes

Resolved! Nexus 3524P-10GX

Hi Team, May I know what is this  ((   N3548-24P-UPG= ))  part number use for . It seem like an port license upgrade for N3548. if yes then why do we need to buy this port license for N3500 series switches. Cisco Nexus 3524 24-Port Upgrade License ...

Max Maxim by Level 1
  • 1851 Views
  • 3 replies
  • 0 Helpful votes

we have establish trunk link between two switches, at the port level, there are some commands configured: logging event trunk status udld port aggressive spanning-tree guard loop load-interval 20 can anyone explain what are the purpose of the above ...

Mary by Level 1
  • 233 Views
  • 3 replies
  • 0 Helpful votes