Switching

Hi guys I have a router RVS4000 and need to reset the password but I need to keep the actual configuration, "IS VERY IMPORT", the guy that use to handle the network pass away and unfortunately he don't left any notes about it. is there anyway to do i...

Hello, I have a 3650 L3 Cisco switch. I'm curious if someone can assist me with the following 2 questions: 1. How do I a simple search for a specific IP address or subnet on the switch to see if any VLAN has it configured already? I have a massive am...

I have a 3750X switch stack(2 switches) using them as Distribution switch. Sw2 is the master and Sw1 is member.  From Distribution switch, we have multiple interfaces bundled as port-channel and uplink to the Core and access switches. issue: As soon ...

I am connecting a Cisco 3650 to AT&T ASE network. We have a CIR at 50Mb connected to a 100Mb port. I need to limit the bandwidth at the switch. We also are using Cisco 3750 and in them we are able to use " srr-queue bandwidth limit 50" on the interfa...

Hello, My question isn't so much about Cisco VLAN configuration, but other switch vendors as they compare to Cisco's implementation. I'm still learning VLAN principles and it setting up a couple VLANs between Cisco hardware and non-Cisco hardware, I...

Dear ColleaguesI must make new small core in the my network.I will use catalyst 4500-x with uplink module.I think, make port-channel with two ports in the each switch - one from the main module and one from the uplink module.Also, I will use dedicate...

Hello all I'm looking for a bit of advise. Please see the attached network topology, I'm looking for opinions on the best configuration based on performance and security. I welcome any suggestions that the experts on the forum can provide to assist ...

Hi,The question is:Can I use all 16 ports simultaneously? Or are the dual porpose ports?Thank you for your answers.Best RegandsDaniel

I am in need of a 10 Gbit Switch with around 24 SFP+ Ports and a minimum of 4 10GigBaseT Ports.  This is for connectivity to several EMC Devices and UCS Servers with SFP+ direct attach and some with 10GbitBaseT Copper Ports on our iSCSI SAN.  Unfortu...

Hello Community, We have Cisco router 2911 and want to configure to allow a external VNC client to access the server using VNC on port 5901 TCP. The internal server is on VLAN 10 with IP address 10.1.1.15 and the IP address of our router interface G...

Hi, the below source IP subnets from DC router, however the same segment already they are using to connect the services with source static NAT. Please help how we can do it. Source IP : 10.6.0.0/16, 10.9.0.0/16 Destination IP: 10.150.156.72 Port 44...

Hello everybody i'm actually configuring a cisco acs server for an entreprise in other to implement the 802.x authentication on cisco switchport with  AD integrated what is done :      *integration of Active Diectory *Device port filtering *certific...