Switching

If a router supports wide metric, does it necessarily use wide metric if the EIGRP process is in named mode? R1#show eigrp protocols EIGRP-IPv4 VR(init-eigrp) Address-Family Protocol for AS(100) Metric weight K1=1, K2=0, K3=1, K4=0, K5=0 K6=0 Metri...

I have a 2 x 6880x with only the built in 16 ports on the chassis. If I create the VSL link between these using 2 ports from each chassis, does this render the other ports to a disabled state that cannot be used? Or does this info refer only to ports...

Hi, Due to maintenance work in the data center, I need to shut down two cisco WS-C6506-E. Both of them have FWSM modules installed and one of them also has a NAM module. Which is the best/safest way to shut them down? I was thinking in doing like th...

the cpu health check results,  specific processors occupy the cpu. and I want to know the role of the following processes (fed,fed-ots-main,cli_agent,iosd,iosd.fastpath) ●CPU State C3650#sh processes cpu sorted detailed Core 0: CPU utilization for ...

I am having Duplex Mismatch issue between two cisco switches. Both switches are connected through SDH. On one Site Switch Uplink Port is RJ-45 and and on one side it is Downlink Port of Switch configured as trunk. What could be the issue? Is there a...

Hi, on the Sup7/8E and 4500-X platforms, is there anything akin to global COS-to-DSCP/DSCP-to-COS maps as on the Sup2T or old-school mls qos? I find documentation on how to configure a table-map and apply this to an interface via policy-map. Does th...

Hi,I have trouble with a Cisco 892 Router from my Internet service provider.Last week we switched from a virtual Router to a hardware Router. But after plugging it in our LAN Switch, the Windows DHCP Server stopped leasing IP's. I got many BAD_ADDRES...

I keep getting the following log, and I can not figure out why.  %DUAL-6-NBRINFO: EIGRP-IPv4 1: Neighbor 10.14.12.2 (Vlan11) is blocked: not on common subnet (10.14.11.1/24) However, I have checked that the vlans are configured correctly and I have...

Hi all, I was checking in the Cisco Feature Navigator, but I got confused, I have my 6509 with the following IOS version  Version 12.2(33)SXH4 s72033_rp-IPSERVICESK9_WAN-M Is this version and IOS ok for vss ? thanks. 987

Hello everyone  Recently I have a network design case for old-large network which currently having problem with STP (in fact the network diameter is too huge for BPDU propagation), as well as VLAN starvation! (it seems their tenant consumed all 409x ...

Hello, Our company has recently acquired a SG500-28 28 Port Gigabit POE managed switch. There are currently 2 companies in the same building using the same internet connection and we want to split the connection so each company is on their own netw...