Switching

Hello, I know that there is a way to stack 3750s, but I only have short stacking cables.  Is there a way to put the main 3750 on floor 1, and run a cat 6 cable from it to another 3750 on floor 2, and have a computer which is plugged into floor 1, be...

Hello Team I am using Cat 4506 chassis with Sup-6E and planning to add redundancy in the setup with New 4506 chassis. Now the challenge is SUP 6E is end of sale and i need to go ahead with Sup 7E . just wanted to confirm if both these different Sup ...

Hi, I just wanted to confirm if I can create an VLAN SVI's on an 887VA router and then associate the 4-port LAN switch ports to these different SVI's? Basically, I am trying to use the Layer 2 LAN port as the Layer 3 WAN port for the Ethernet handoff...

Hi Everyone, Need to confirm to know RP for the multicast group I can run the below command show ip pim rpGroup: 224.0.1.40, RP: 10.2.10.1, v2, uptime 1y2w, expires never Regards MAhesh

I will be replacing my firewall in the next few months and didn't want to do a forklift upgrade. I would rather install new firewalls to test before removing the old ones. A watered down version of the current setup is the Core Switch does the routi...

Hi all, looking for opinions here :) We have a bunch of 3750-X switch stacks running 12.2.55-SE9(MD), and I was wondering whether anyone has experienced any problems with the 15.2.4E1(ED) firmware ? The reason for the upgrade is that we are trying ...

Hi All, Not sure if someone can help clear this up. I have a route map below route-map test1 permit 10  match ip address prefix-test  set extcommunity rt 1:1 additive Is the above setting the prefix list test with a RT of 1:1? if so is that all it ...

Hello everyone!  Your support section has helped me more times than I can count, but I am completely stumped on this one, and I was hoping someone could offer a possible solution.  This might be a dumb question, and I'm prepared for a dumb answer. I...

Hi all; I want simple abstract or summary for this subject (Redistribute IPv6 BGP Default Route in EIGRPv6 Configuration)http://www.cisco.com/c/en/us/support/docs/ip/ip-version-6-ipv6/113598-redis-ipv6-default-route-00.html

Hi, i am surprised why people configure enable and enable secret passwords on same device as under: enable secret 5 $1$dmNX$N.BY/OQt/VPfmvRd0Xfo3/ enable password 7 0205164218120E2D6C4D000A0618 BR AbdulKarim

Hi, IOS in Cisco 3560 has been deleted mistakenly. I am trying to recover it through XMODEM. I have tried three times but whenever I issued the boot  command as  boot flash:/c3560e-universalk9-mz.122-55.SE8.bin the following output comes out as unde...

Hi All, Guys I need to your help to come out from the issue:- We have terminated the 2 ISP on our router (only 1 router).we have advertised 2 subnet of /24 to ISP1 & /23 to the ISP 2 .& implemented the BGP with our own BGP ASN.we have configured our ...

Hi, I have just installed a new 10 Gbps core for a small customer comprising two Catalyst 3850-24XS switches that are stacked together to form one logical switch. The 3850 stack is running software version 03.07.03E The old core which comprised two C...