Switching

C3750e-universalk9-mz.122-55.SE1 It logs the below error multiple times Sep 30 08:37:54.851: %SYS-3-CPUHOG: Task is running for (2097)msecs, more than (2000)msecs (0/0),process = SNMP ENGINE.-Traceback= 19797E4 1979920 1952618 1952654 1B171F4 1B154E4...

Hi, I am planing to propose DMVPN solution to one of my customer through my L2/L3 MPLS. There One Hub site and 500 Spoke sites. I will control bandwidth of all Spoke sites to 2MB (more than enough), and 1G to Hub site. So I think there is no bandwidt...

I ran show tech support on 4500x vss and it never finished running. Connected 2nd telnet session ran show proc cpu it never completed. Connected again later ran show run. It wont complete.Any way to recover without rebooting the switches?

Hi folks. I have a 3750 as my primary switch to the uplink and sub-switches, 2950s. I have a Dell PE 610 connected on one of the 2950 switches that's crawling on download speeds. Tested by wget on a few Centos mirrors. My output for the VLAN is below...

I'm hoping that somebody may be able to help me.I have a very bizarre issue that I can't get my head around and have completely run out of ideas.I have 2 6500 core switches (switch 1 - primary [10.207.0.9]/ switch 2 - secondary [10.207.0.10]). Both o...

I want to set up 2 tunnelsFrom Site A to Site BFrom Site A to Site C Config Router site A pseudowire-class PW_2 encapsulation l2tpv3 protocol l2tpv3 tunel ip local interface GigabitEthernet0!crypto keyring key_tunel_UNION_T2370    pre-shared-key addr...

Hello!As mentioned in documents "All FabricPath VLANs use conversational MAC address learning."Here my configuration-vlan 100-200,252  mode fabricpath Configured 2 interfaces vlan with ip addresses- n7k-right-bor-core# sh ip int br  | exc unasIP Inte...

I am trying to change the management IP address and gateway remotely. I connect and create a new SVI with a different IP address and change the default gateway. Loss of connectivity is expected. Once i lose connectivity I am not able to establish the...

Hello All, I have done NAT config on the switch but it is not working. If anyone could be of help. interface Vlan25  ip address 10.18.95.126 255.255.255.224 ip nat outsideend interface Vlan2 ip address 192.168.1.1 255.255.255.248 ip nat inside show r...

How to fix '%ICC-DFC4-5-WATERMARK: 801 multicast tx pkts for class L2-DRV(FC) are waiting to be processed' , which occurs once in a week..platform : cisco WS-C6509-NEB-A and software s72033_rp Software (s72033_rp-ADVIPSERVICESK9-M). Any feedback appr...

Hello,We have one 2960S Switches and created Multiple VLANs. While Pinging from Member PC to Member VLAN IP on Switch, we are getting Higher TTL response.But pinging from Member PC to Member PC, we are getting Normal Ping Response. Is there any Probl...

Dear all i have a ploblem on Cisco Catalyst Supervisor Engine 8-E chassis WS-C4510R+E , how can i check the number of active 1giga uplink port for each supervisor?