Switching

 Wondering any one has successfully set route tag for EIGRP routes?What I am trying to achieve here is to set route tag for the summary routes of the connected interfaces and subnets of some other connected interfaces.Let's say an ISR router R1 with ...

Hi chaps, I am trying to find out what's going on in a network, where I currently have loads of switches, majority of which are running RSTP, but there are still some running PVST+. I came up to this case, which surprises me a bit and I decided to pi...

Hello Support Community,I have a concern regarding EIGRP Stub Configuration on our Catalyst 3560G in IOS 12.2.50SE5 IP Base. IP Base Image is only supporting EIGRP Stub. Problem is that I want to redistribute a static route into EIGRP in named mode w...

Hello,I was wondering if anyone is aware of a utility (paid or free) that is capable of applying configuration changes to a switch's interface through a web GUI (please see more specifics below)We would like to be able to select a switch port templat...

I have an 2901 router  and I am getting the strangest ping results from a NATed IP address on my DMZ.  I am about at my wits end and would appreciate any help.From 192.168.1.X:C:\>ping 192.168.12.140Pinging 192.168.12.140 with 32 bytes of data:Reply ...

 Wondering any one has successfully set route tag for EIGRP routes?What I am trying to achieve here is to set route tag for the summary routes of the connected interfaces and subnets of some other connected interfaces.Let's say an ISR router R1 with ...

hii have new project in with the bellow product : 20 X WS-C2960-24TC-S 2 X WS-C3750X-48T-S 2 X WS-C2960S-24TS-S i need to configure this switch in order to work without having vlan, first the 2 core switch for redundancy, then each catalyst switch 29...

Hi people.I'm buying Cisco switches to my home lab to practice VLAN and have some doubts, would someone kindly help me?I'm thinking of buying two 300 series switches for the servers (VMware boxes), configure two separate VLANs for VMs and two other V...

I have a port-channel with vpc from a pair of 7K to a pair of 5K and from the 5K to the 7K. I need to know the Cisco recommended "spanning-tree port type" for this link. By default it uses the "port type normal" but I need to know if this is the reco...

Hello, Is there a way I can make routing decision on a cisco router after the NAT? I want to route traffic to a specific next hop after the NAT has happened.Is there a way to do this? Thank you.

Hi, I need to packet capture all traffic for a specific vlan configured on an etherchannel trunk interface (on a NEXUS 5548). A local span was successfully configured, however there appears to be no option to filter a specific vlan for the monitor ...