Switching

I am trying to connect to a new switch using the USB Console Cable. I have downloaded and installed the 3.1 drivers from the website.I have also looked at other posts here on how to manually install the driver but that is not my problem. I get an err...

We are close to implementing UCS into our existing data center. We have a pair of 4506-Es and were planning to run VSS. Well, i found out today that several of our line cards are unsupported and VSS will not work. The two 4500s are running HSRP. I'm ...

I have a new N5K switch, and I want to downgrade the NXOS from 5.2(1)N1(1b) to  5.0.3.N2.1 , and go the following incompatibility information:Note - this is a test switch without any configuration on it. Im downgrading it to test upgrade procedures f...

Hi,At my organization, I work on my companies engineering team and have been tasked with completing a few questions from an RFI regarding the 3850.  Does anyone have any resources for this outside of the standard Q&A and Data Sheets?  I am not as flu...

For some reasons, my timestamps are wrong in my log. NTP is working and a "sh clock" looks correct. Any ideas on what could be causing this? My code is 12.4(24)T3.Log snippet from 10:36am today000086: Dec  9 16:30:00.736: %CRYPTO-4-PKT_REPLAY_ERR: de...

Dear Sir/Ma,Please kindly help me identify the cards from the attached file.I want to know the ones that are card.brsamson

HelloI working on a scenario,which is as follows:There will be 3 l3 swithes; PE1 PE2 and CE.PE1and PE2 are from service provider.All switches are connected via /29subnetSay subnet will be 172.16.1.0/29PE1 having svi 200  with ip add 172.16.1.1/29PE2 ...

Hi everyone,I have a single SUP7-E (no redundant supervisor). Of the four uplinks, which are the options availale? Can I use the four uplinks as 10G interfaces? Could I use two uplinks as 10G and the other two as Gigabit?Thanks

Dear all,I tried to configure a port-channel between a nexus 2K (2FEX) and a brocade VDX (VDX6710).As you seen below, my configuration :N2K-------Po10switchport access vlan 200Eth101/1/6switchport access vlan 200channel-group 10 mode active (used LAC...

Will each and every PC generate gratuitous ARP when added a LAN Segment.Can somone please explain about thigs ?     Regards,Chandu

Hello Everyone,          Looking at this configuration would it be correct to say that the 50.50.50.17 subnet (Subinterface 50) would not be translated due to that it does not have the "ip nat enable" command when it exits fa0/1 (eventhough ip nat en...

Please help me!!!!!Please find below diagram. Between R7 and R1 RIPV2 is running, Between R1,R2,R3,R4 EIGRP is running and R3,R4,R5,R6 OSPF is running. I have redistributed RIP into EIGRP and vice versa at R1. At R3 and R4 redistributed EIGRP and OSP...