Switching

Hi,I hope everyone is doing well! One of the things that I'm doing right now is updating our network diagrams and I ran into an odd situation.We're running an MPLS network and I've been curious why the transit paths that a packet is taking in our LAN...

Hi,I have a 3825 that I am trying to connect to a 3508 Switch via 1000BASE-SX.  I have an SFP in Gi0/0 of the router and a 1000BASE-SX model in Gi0/8 of the switch.  Both the switch and the router can see each other when using the "show cdp neighbors...

Hello community!I have Cicso 4506 Chassis (WS-C4506) with a Sup IV (WS-X4515) currently running IOS version 12.2(54)SG1 and ROMMON 12.1(12r)EW.Prior to upgrading to 15, I am looking to upgrade the ROMMON. The minimum recommended is 12.2(31r)SGA4. I n...

Hi,'What is the major difference between these two commands:ping vrf ABC 192.10.2.2 ping vrf ABC 192.10.2.2 source vlan 6I am able to ping a voice server from 6509 router with the second command but not with the first one.There is just one vlan(vl 6)...

Hi everybody,here is my current config:Building configuration...Current configuration : 4134 bytes!version 12.4no service padservice timestamps debug datetime msecservice timestamps log datetime msecservice password-encryption!hostname xxx!boot-start...

Hi,one of the ports of 6509 router to which MARUTA encryptor (Clear port) is connected is showing as " P2P Dispute"  and is put into BLK state.What could be the reason?Can i get some valuable info/soltuion to this issue

Hi there!I recently discovered on one of our catalyst 6500 switches an increasing number of switch fabric rx errors:switch#show fabric channel-counters slot channel   rxErrors   txErrors    txDrops  lbusDrops    1       0          1          0       ...

Hi Guys,Our company is looking for a switch that's reasonably priced so that we can monitor the bandwidth for different companies on an interface by interface basis. Cost is a little bit of an issue, so I was thinking of something like a 3560GBasical...

Hi Friends,I am trying to analyze the capacity of one of my L3 switches for provisioning a new connectivity. When I check the TCAM util of the device I can see that the QOS aces and the PBR ace's are almost full. On this device however there are no ...

                   We are facing teh issue with high cpu process. In the output could see Cat4k Mgmt LoPri is taking 95% utilization. Model: WS-C4506-E (MPC8548) processor (revision 9)cusred024c4n01#sh process cpu | ex 0.00%CPU utilization for five s...

Hi All,I have a topology were, im using a Switcg 3560(L2), and a Router.. and 10 Systems connected to the Switch ( Access Ports- Port Fast configured).Highlevel Diagram:SYSTEMS(A) (VLAN100) >>ACCESS>> Switch(Sw1) >>>> TRUNK>>>> Router(R1)Eveerything ...

I can not connect my WUMC710 wireless-AC Universal Media Connector to my routerI have tried on 2 totaly different networks with different routers by using the WPS Switch on the devices but it does not get noticed by the routers!Also i tried to set up...