Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

traffic is sent to ASR1 as it's booting up but no traffic is getting through since it hasn't fully come up. We want to have it routed through ASR2 until ASR1 is fully booted up. please let me know what I can do to accomplish this. We use ASAs 

kylehash by Level 1
  • 1700 Views
  • 10 replies
  • 1 Helpful votes

Resolved! STP Tie Breakers

The following information is from the CCNP Switch (642-813) Official Certification Guide (Copyright© 2010 Pearson Education, Inc.)Chapter 7: Traditional Spanning Tree Protocol - Page 135 Under section: Electing Designated PortsCan anyone tell me what...

HelloI have LAN with 192.168.1.0/24 and  i do nat to allow the LAN access to internet  .also i have in same LAN 2 ubiquity antennas i need to configure it from outside .how i can do that?thanks ,,,,,

Hello. I have 2 Nexus n9k and this is gonna be my first VPC setup. I have 4 x 25Gbit links between the two switch because this switches gonna serve for storage devices, I need speed and low latency. I did not use 100G uplinks because I need them for ...

Ozy by Level 1
  • 11284 Views
  • 9 replies
  • 2 Helpful votes