Have tried:service-module wlan-ap 0 reset default-config service-module wlan-ap 0 reset Still can't login.Any help would be gratefully received.ThanksKevin
Hi All,Does anyone know how many VRF-Lite instances a Catalyst 4948E-E can support? I dont need many routes in each VRF. Lets say 1-5 ish to be safe..Thanks a lotMatt
We are having an issue on a 2960 switch when we add a new device to the switch (in this case a printer), the rest of the devices drop.They only come back if we reboot the switch.Any ideas?
Hi, the 2960 series with LAN Base image now supports a limited L3-routing functionality.I tried to test if HSRP also works, and surprise, it works.Because I do not find any document with infos thats HSRP is official supported on the 2960, does naybo...
Hi,We have an issue with one of our switch stacks.The stack exists of 2 switches WS-C3750-24PS-S with IOS C3750-ipbasek9-ms.122-44.SE.bin Users experience slow download capacity when downloading big files. When those users are repatched to the other ...
Hi,I know that we should use VACL for filtering L3 traffic on the in the vlan, but I also know some people still using ACL inside a vlan. Can someone elaborate why we should not use ACL inside a Vlan or point me to the right documentation?Regards,Dav...
Dear All,I would like all of you recommand which model switch that can support fibr(24 port)? now i have swich switch L2 around 20units with fiber uplink, and i want all access switch connect fiber to Core-switch with fiber port?Best Regards,Rechard_...
Hi all,My new Catalyst 2960s is unable to boot up after working fine for couple of days.Error message is in the attached.Would anybody advice what's the problem ? (firmware / software).Thank you,
Hello, I have a 2960G and I use the Express Setup mode to connect for the first time on the switch with Internet Explorer. All goes well, I can connect my laptop to the switch with 10.0.0.1 IP address (using Interner Explorer), but a windows asks me ...
Is it possible to have HSRP set up across a trunk (different sites), and depending on the site, have the local interface be the primary, remote site be the secondary?For example:HQ VLAN 10 interface = 10.0.0.2DR VLAN 10 interface = 10.0.0.3HSRP Stand...
On a 4500 switch, it was seen that with only one power supply running, the status led on both supervisors was amber. and it turned green only when both supplies were turned on. Why is it so and is it normal?thanks in advance.
HiIam working on a project to role out IPv6 to our network. We use HSRP to provide resilience to our customers instead of using BGP between us and them. Looking at the below link HSRP for IPv6 only allows a virtual Link local address is it possible t...
I have recently loaded a new IOS image to flash: via TFTP. I deleted the old one and then modified the boot parameter. I beleive I missed something because when I reloaded, I boot into helper mode and I have the following prompt.switch: If I show...
