Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello,We're running a switched LAN environment, made up mostly of 3750 switches (and switch stacks). One one of our "core" switch stacks, we're running two different SPAN sessions for IDS, etc. I tried to add a third for another appliance, but the IO...

Hi all. I've a 30Km ring of SMF in wich the costumer wants a network access every 2Km. Therefore, two segments have been hypothesized (8 switch segment, 4km apart and each phase shifted 2km) to cover the entire stretch of 30 km with a total of 16 296...

Hi All,I had a live site, where the router Cisco 1841 has been upgraded with IOS c1841-advipservicesk9-mz.124-5b.bin...After upgrade i had checked, the IOS was uploaded succesfully.But after boot cammand with the IOS, Router is not coming up..Did a H...

I have a series of 2960-24LC-S switches running IOS 12.2(50) SE4. I cannot get Auto QoS to run on the ports as is done with a 3560 for example. Anyone have any ideas?

nshoe18 by Level 1
  • 522 Views
  • 1 replies
  • 0 Helpful votes

Hello.I have been working with a company that provides wireless infrastructure for large events (such as conventions).  The company has a pretty extensive wireless infrastructure (25 access points...wireless lan controller), but they have no WAN rout...

msee by Level 1
  • 409 Views
  • 1 replies
  • 0 Helpful votes

Hello everyone,I am trying to install Cisco Configuration Professional 2.4 Express on my 2821 router. During the installation process, I get notified there is 0 bytes available of routers flash memory. When I run a show flash: command, I receive the ...

I am working on an old (problem has been occuring since 2009) issue for a client.  They have some VMS systems and for certain reasons must run DECnet.  They seem to be having intermittent file transfer issues between the VMS servers.  The issue occur...

I have many VLANs setup on one network using a HP switch.  I am trying to extend that network to a cisco switch via a fiber connection and then convert to gigabit for cisco.  I Have a link light on the cisco but when I add a pc via a static address I...

Hello Experts,Users in my LAN are facing the Wireless access issue. When I checked that though wireless is connected but the IP address is not associated for the Laptop.Many users are complaining this issue. How can I narrow down the causes using WLC...

Japan Learning @ Cisco様の指示により転載いたします。はじめまして。初歩的な問題かもしれませんが、ご教示ください。Cisco 1812Jを利用しており、現在f0/0をWAN側として、f0/1をLAN側に設定し、ブリッジのような役割で利用しております。その他のポートは一切利用しておりません。(shutdown状態)今回LAN側の機器を冗長化することとなり、2台接続する必要があるため、スイッチポートを利用することになりました。この場合、スイッチポートにVLANを設定してIPアドレ...