Switching

I have configured an multilink, problem is after configuration, end to end connectivity was fine, but the traffic which is being initiated from my end is via different path, found that the FD is lesser in the different path, i need to use delay value...

Hi,I need to replace SUP engine on Cat 4516 switch,with a new one.Can anyone help me know the procedure to do this & also how much outage time would it cause?Would the config have any issues with this.Thanks in advance!

Hi,I have a small lab with:2 x C26201 x Pix2 x 3550I have seen a few racks but the sizes are 6U, 9U, 12U what is this and which would I need to fit my kit in?

We will be adding 2 new Cisco 6500 onto the network. This 2 switches will eventually replace the 2 old ones. Procedures will be as follows:When introducing the 1st switch I will do the following:- make sure its setup as a client- make sure revision...

error massage: POST: Inline Power Controller Tests : BeginPOST: Found inline power controller write failure, inst 0POST: Inline Power Controller Tests : End, Status FailedGbic port not functions.why this happen coz of hardware or software?

Does anyone use smartports? They look like a great idea. When I do searches for smartports all I find is people saying how to configure them, but no opinions as to it they use them or not. Please let me know what your thoughts are on this feature....

Hi all, we are in process of putting in a new lan,the edge switches will comprise of 2960's or 2975.In our partner company in Germany they have switches in closets, all with 1 invdividual connection to a core switch, in the UK we currently have other...

Hi,We have en existing Internet connection using our Cisco 3725 router (ISP A). The router does the NAT and here's the existing default route:S* 0.0.0.0/0 [1/0] via 1.2.3.153This router has a "16 Port 10BaseT/100BaseTX EtherSwitch". Now we have a...

Hi,I just completed my CCNA course and want to practise STP. I have only 2 switches to I guess I need a 3rd. Currently I have a 3550 and a 2950, what would be a good 3rd cheap choice as I guess 3 is the minimum?This way I can have 3 trunks working ...

Hi,I have 2 Switches A& B connected to each other over Portchannel interfaces each with 2 physical interface in it.My query is related to physical errors that occur on one of these physical interfaces.A is connected to B via PoCh with interfaces gig ...

Hi I a trying to set up a Telnet connection from my computer to a pair of switches and 3 routers I dont want to console into the devices everytime. I want to use telnet to access each device.How can i set this upstep1. I need give password to vty l...