Switching

Hi,I have a 2948 switch with an IOS that i am fing it difficult to use,most commands are not the conventional ones,Could any of you give some guidance on how i can do this upgrade?

Hi there;Can anyone tell me when you would use an FXS card to connect to a PABX rather than a FXO card? Can an FXS card be used with a PABX?Regards

Hello To all,I was wondering if you may please explain to me what stands behind the network 0.0.0.0 0.0.0.0 command if put under ospf/eigrp config? and how will this command effect redistribution?any help in the matter would be greatly appreciated.Be...

I recently introduced VTP pruning on a LAN, and now I have some connectivity problems on certain VLANs.1. Is pruning based on whether the switch has any active access ports or unpruned downstream trunks on the VLAN? Or is it based on whether there a...

Hi,I have got a cable modem (model above) connected via ethernet to a C871 with 1 Fastethernet port and 4 L2 ports.I have configured the following so that I can ping the gateway of my ISP. I have been given a static IP address.Router#sh runBuilding c...

just for a curiositywhat will happen if I upload 48 port switch configuration to a 24 port switch using TFTP. I want to know will the VLAN configuration would work i.e. only for the port applied on the Switch.I could do this myself but just to save t...

How does variance help in EIGRP load balancing ? How do we decide on the variance value & where do we configure this ? why would we require "trafic share min" since it's equivalent to having no variance configured ?

Dear respected peers and Gurus, I've been racking my brains here. Doing an exercise and have managed to get full connectivity throughout the frame - i've added a seed metric and was just wondering if the frame "switch" is seen as totally transparent...

Hi,one of my server is connected in the same network with my Switches. All the ports are open to that Server but I m not able to telnet with the specific port to that server. Can you please help me out on this issue. How do i telnet with a specific ...

I have questions about the design of our companys switch fabric. We are questioning the design of the Medical IDF. The network is currently setup as in the attached Viso drawing. 1. Would it not be better to have a trunk going to each data switch an...

Hi, I have gbit interface card on Cisco 3825. Can I configure and set the interface to 100 Mbps full duplex and the switch are also configured as 100Mbps full duplex ?Here is the configuration on the router :interface GigabitEthernet0/0 duplex ful...

Alrighty, Im in the planning/researching stage of a qos rollout. Im not sure if I should get a consultant to get it done within a day or try it myself and learn a thing or two. Im new to qos and read alittle so far from the manuals downloaded off t...

Hello, Is there a 1RU switch that has muliport support fo 10G fiber?