Switching

Hello,I have attached the diagram of the setup as it is and will write a sample of the config on each Vlan. I am running GLBP and seem to get a duplicate IP issue which is puzzling?? All ports are trunked from the two 6500's to the 4948's. The fiber ...

Hello everyone,I have 2 types of switches WS-C3524-XL-EN and WS-C3550-48-SMI. I am looking to update the IOS on the switches but I am a bit confused on which software to choose. Can someone lend a helping hand or point me in the right direction. Th...

Hi All,On cisco website I found this info:The WS-X4418-GB Gigabit Ethernet switching module offers two dedicated 1000BASE-X (GBIC) ports (ports 1 and 2) and 16 oversubscribed (possibly blocking) 1000BASE-X (GBIC) Gigabit Ethernet ports.Ports 1 and 2 ...

In my practice i realized that setting clocks always change to "a dead old time of 1993 i think this was the factory default" whenever i restart the router, even though the new "clock set" is saved to "startup"Can anyone please help as to why this is...

Hi,I want to configure the Layer 3 design between the access switches to the distribution switches "routed port". I read alot of documents that recommend this design instead of L2 & STPs loops.My question is that i have wireless controller with LWAPs...

We are planning on buying one of Ciscos appliance solutions (the ASA 55xx series) and would like to know if it's possible to bridge our RIPE assigned external IP-range to be used on an internal interface?Our business demands that we can continue to u...

Can anyone get me the FCC ID off of a 3725 and 7204?

We have 2 core switches with a lot of gigabit uplinks to other switches. Now there have been discarded frame reports on a lot of these gigabit interfaces.How can I accurately troubleshoot this and also to resolve this issue?Thanks

Hi all, further to my questions, can anyone one tell me if put my phone say on vlan 10 and my pc in vlan 5, the pc plugs into the phone and then phone to switch, in this scenario are both pc and phone tagged ? and when we say tag, does that mean eith...

We currently have our coporate office running in Class "C" address space (253 hosts)and are just about out of addresses. We use a combination of 3750 and 3550 switches in our server room. Currently around 150 PCs, 50 Servers and 50 other devices (pr...

Hi experts,We have a core switch 6500 with vlan 10 & vlan 20. Both vlans are set to auto-auto (speed/duplex). We noticed that when we connect a PC on vlan 10 & transfer a file say 1gb. The rate is between 30-40mb per sec, so it's fast enough. But whe...

ap1231g unable to pass traffic thru gigabit int on WS-X6148A-GE-45AF.switchport settings:interface GigabitEthernet9/1 description wireless: AP-020 switchport switchport trunk encapsulation dot1q switchport trunk native vlan 301 switchport mode trunk ...

I have 1 server based in Windows 2003 server. It's situated about 3 Km from 30 pc (clients). What solutions Can I have to make to create a communication Server-Client and create my domain on this server?? Want to communicate through optical fiber fro...

I have a router with two ebgp neighbors and one ibgp neighbor. The router recieved the networks with different communities from the ibgp neighbor and with community-list and route-maps we decide for which ebgp sesion advertise the networks. But when ...

when i try to find specific item in the sh run i should use more parameters like the followingshow run | include (interface | 10.1.1.1)Is there any DOCs on cisco explain the show command with detailed parameters?