Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

HiWe have put a PXE server in a LAB net.The DHCP and the PXE isnt on the same server so I have configured two helper adresses on a 2611. Ive also starter ip mulsticast-routing and ip pim dense on the interfaces.But still the PXE boot doesnt work.I ge...

killroy by Level 1
  • 1043 Views
  • 6 replies
  • 0 Helpful votes

HI Expert's!i have a 1 6509 Sup 720 act as CORE;and another 2 6509 Sup 720 acts as Destribution i need to config<CORE>For Supervisor redundancy engine.plz provide me a simple config to achieve LIKE this setup JUST for the CORE.I HAVE Link" http://w...

alsayed by Level 1
  • 405 Views
  • 3 replies
  • 0 Helpful votes

we have routers with rip configuration and using the authentication using md5. in show run we could see the encrypted key string.we are on the process of adding spokes to the network but we forgot the actual rip key string.how can i see the decrypted...

A customer who has 2mg link from ISP1 would like to purchase 2nd and 3rd 2mg from ISP2, The link from ISP1 is connected on RT1 and The link from ISP2 is connected on RT2 ( RT2 has 2 link )can some one tell me how can i do a load blance as well as eac...

I received a Catalyst 4948 from my Headquarters and they didn't send any passwords, I did the password recovery for the Catalyst 4500/4000 Supervisor Engine II+/III/IV/V Module and it appeared to succeed, However Now When I reboot it goes straight t...

I am trying to stack up few Catalyst 3750E switches which they will be mounted in different racks. One of these stackwise cable was being just little short even using 3 meter one (CAB-STACK-3M=), I'm wondering if there is anything longer than 3 mete...

Hi Experts!i have to know,1)how can i Configure Port-Security on server vlan and static mac-address mapping for these servers on the DMZ segment.10xs

alsayed by Level 1
  • 352 Views
  • 3 replies
  • 0 Helpful votes

I am really trying to push L3 in the closet using 3750s. However, it is very frustrating when the most basic stuff (i.e. multicast routing) is not supported in the IPBASE image--but I hear this is supposed to change in an upcoming release. Upgradin...

We had a co-worker get fired and took the passwords with him. We have txt files of the config but need away to decrypt the level 5 password. I would just run through the password recovery reboot but we cannot take the switches out of production. A...