Switching

I think we are over subscribing the ports on our WS-X6548-GE-TX= (Catalyst 6500 48-port fabric-enabled 10/100/1000 Module) line cards in our 6509. This 6509 is the access layer for our servers which are being migrated from 100MB connections to gig c...

Hi,I read that although the root bridge election process is automatic you should manualy select a primary root bridge and a secondary root bridge because you could have an access switch acting as the root instead of a more powerful equipment.Is there...

Hi, with the following the switch is working perfectly with what ever i configured in Cisco ACS....aaa new-modelaaa authentication login default group tacacs+ enable localaaa authentication enable default group tacacs+ enableaaa authorization exec de...

I am editing the config of a 1712 remote vpn when I destroyed and recreated crypto map. The change I made took. No problem, but the old map still remains. This the config:no crypto map VpNmAp 27 ipsec-isakmp crypto map VpNmAp 1 ipsec-isakmp set peer...

Hello All, This is my first post.I would like to know if I can do the following.... Instead of having 8 different DHCP servers, I want to have one single DHCP server in my building (8 Floors)running a superscope for all different subnets. Using 3750'...

Hi,There is a very long story behind this, but ultimately what I need to achieve is the following:I have an 831 router sat on a LAN. It receives its eth1 (outside) address by DHCP. I also want to pick up a second DHCP address that can be used for hid...

could any body tell me what is forwarding bandwidth, forwarding rate and wahts the diferance bet both.What is backplane, backbone and whats the diferance bet both.RegdsAK

Hi,I am in the process of adding redundant sup1, sup2, and sup720 engines to our current 6509 switches. So far we have seen a brief loss of connectivity to traffic traversing a switch during the hot-insert of a new supervisor card. This outage causes...

I have installed a new 2950 switch, connected to a 6509 with GBIC's.I cannot ping the 2950, it is on the same subnet as the 6509. If I run 'sh cdp n 3/9 detail' on the 6509 it gives me details of the 2950. If I run the same command on the 2950 it giv...

Hi all, If I wanted to redistribute eigrp 100 into 200 and vice versa, Do I need to set any metrics ?

hi can any one tell me what is difference between Layer2 and Layer3 ether channelregdsShashi

Hi,Is VLAN tagged traffic (dot1q or ISL) that enters a switch tested against a VLAN access map, or is it classed as already being in the VLAN beacuse it is tagged and therefore bypasses the access mapRegards