Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I am looking for the proper config settings to run a traffic generator into 1 port, then out 3 others with no restrictions. For some reason xmission has been cut short by my catalyst 2900, whereas it should continue flowing through the switch without...

Hi I would really appreciate if someone can help me. I am new to Cisco routers and this is my first time configuring a router. How do I access the router via a PC? I have tried connecting via hyperterminal to no avail. If I telnet through a windo...

Hi Guys, I am seen this error message on a 4000 access switch "%SYS-4-P2_WARN: 1/Traffic from permanent host 00:08:a3:dd:a7:dd but seen on incorrect port 1/2" That mac address is from the switch itself. I don't know much about this type of problems,...

pfizcisco by Level 1
  • 789 Views
  • 4 replies
  • 0 Helpful votes

I have a Cisco 1720 router and I am able to log in to it via telnet and enable the advanced features. I want to match up one of our external IP addresses to an internal IP address. I guess that I use NAT to do this but I don't know any of the comma...

Hi all,I have a little question for you.I have a FR 2 Mbits on my serial 1 (1721 router)When i do a show int serial 1 i get the following CAPOROUTER#show int serial 1Serial1 is up, line protocol is up Hardware is PowerQUICC Serial MTU 1500 bytes, ...

gserghiou by Level 1
  • 550 Views
  • 2 replies
  • 0 Helpful votes

Cards and Modules have they names printed on the outside of each card/module... (NM-HD-2V / VIC2-2BRI-NT/TE )Is there a #show command that shows me this information ????ThanksAndrei.

I searched ntp server in google.some result was showed, but I can't find a free NTP server. I wish to configure to our router in NTP because the log's timestamp show to invalid time.I had configured clock set which using to configure equipment time. ...

Hi All,I have just installed a tftp server on my machine for billing purposes for a PBX system.To my surprise i saw 2 routers trying to access this tftp server and request a configuration file.How can i disbale this tftp request on my routers ???Hope...

gserghiou by Level 1
  • 557 Views
  • 1 replies
  • 0 Helpful votes

In our campus we have a network of 192.168.2.0 with cisco switch 2950.A segment called seg-1 is pulgged into switch port - 8(total 5 segments),& our proxy server is plugged into port 3. now what i want is that i want ,to restrict seg1 computers to ac...

Resolved! 2500 Series IOS

What is the limit to the IOS that you can run on the EOL 2500 series routers. I have heard up to 12.2 but have also heard people running 12.3. I want to run 12.3T on all my routers in my lab but im not sure if you can run it on the 2500 series rout...

Hi Budieslet me know is there any comand by which i can specify description with the Secondary IP addresses assigned on an interface ?i know i can describe an interface but how to describe an ip address is my problem.I've already unsuccessfully trie...

b.chhetri by Level 1
  • 685 Views
  • 1 replies
  • 0 Helpful votes