Hi Guys,I have an AIM-CUE on Cisco 2821 Router when i attempt to pen a session with service engine 0/1 i have on console : waiting. Causing the end users to be unable to listen their voice mails.Do you have an idea about that ?Thanks
Hello, we have two radius servers <Radius_1_PUBLIC_IP> and <Radius_2_PUBLIC_IP> When the first shuts down, the AS5300 Gateway does not change to the backup server.aaa group server radius H323-calls server <Radius_1_PUBLIC_IP> auth-port 1812 acct-port...
Have anyone configured a SIP Trunk to Telia on CME 7.1?This is what Telia THINK the sip-ua shall look like.Config:sip-ua authentication username 00000000 password xxxxxxxxxxx no remote-party-id retry invite 2 retry register 3 timers connect 100 regi...
Hi everyone,I got two questions about CCME.1. the directory entries defined under the telephony-service are accessible to everybody who has an IP Phone. Is there any solution to make private directory entries for each IP Phone so that IP Phone does n...
is is possible to have the router (2851, advipservicesk9-mz.124-24.T, Cisco Unity Express 7.0.1) encrypt the password used for the CUE web login so that it is not displayed in plain text? Service password-encryption is set on the 2851.Thanks! Stev...
Has anyone heard of or experienced 4CIF video leaving an ATM interface on a Cisco 3660 (12.3(6a)) and at the next hop ATM switch seeing CRC errors, causing packet loss and bad video at the far end video unit? If the video is switched to CIF resolutio...
Hello,I am having a small problem with our Cisco 5400 device, I have 5 T1 lines from Verizon all in a nfan group for some reason i am getting the following error: disc subsys=ISDN, disc code=0x29, disc text=Temporary failureon the call log, i have lo...
Hello!I have a problem establishing point-to-point video calls between different endpoints. The scheme is as follows.CCM has a GK-controlled trunk connection to an IOS gatekeeper on a 2821. CCME also registers there as a gateway. I also have Polycom ...
Hello,outbound calls to the SIP provider work fine but inbound calls fail after the call is picked up. The receiver of the call sends a RTP stream, and the pstn side only hears ringing then fast busy.Could this be a code negation problem or a fast st...
Hi,i am facing problem cisco ATA 186 ivr, i can't hear the ivr menu on pressing the led button on top of the ATA,my phone line is connected with line1, is there any way to know the ip address of the adapter. Hope someone will help in this issue.thank...
