TelePresence and Video Infrastructure

Hello,I want to establish Video Calls between 2 independant IP Telephony network, one with a CUCM 6.1, amd the other one with A Call manager system. I have a Cisco 2811 on the Call Manager side, who have a IP Public adress.The Voice Call is working w...

I have asymmetric Internet, Download 1500 kps and Upload 300 KbpsI can control the upload but i can notthe download.

i configure the MGCP and connect the router to the pbx but when we call from ip phone to the analog phone we can hear anything it vice versa.anyone can help

Hi,Is it possible to do a 3 conferencing (adhoc) using a CUCM6 ?i.e after calling one person, I call another person using the conference adhoc and both will be in conference with me.thks.

Can you let me know if you can have a mixed mode Video conference i.e H323, SIP and SCCP. I know you can dial into a MCU using a "Meet Me" set up but can a H323, SIP device conference, set up a conference in a SCCP end point and vice versa. A call st...

Hi, allI have found the following dial-peer in several case stadies. It match all called number, but there is not voice port configuration under it. So what is the effort for this dialpeer?---------------------!dial-peer voice 10 pots incoming called...

Would it be possible to display the IP address of an incoming caller on my caller ID?The calls are from 7931s at remote locations to another 7931 on my desk.

Can someone confirm whether or not Meetingplace Express when combined with a MCU (specifically the 3515 MCU-12 5.5) WILL provide multiple video layout (Continuous Presence).I vaguely recall seeing a simular setup with the stack video layout but there...

I have Snom phones utilizing an Asterisk server. Sniffer captures are showing what I expect and ports 10686 as the dest port from the phone. However RTP packets sent right back from the Asterisk server are destined for port 50488.Does this mean I nee...

Hi,I have a DMM 4.1, Digital Media Encoder 1000 and Cisco digital media player 4305g.I get to the point where I need to configure the values for the Video Portal module (http://<DMM_IP_address>:8080/DMM/) and its asks for the instance name which i do...

I need to configure a call, in an UC500, between two IP comunicator with cisco Video advantage .Voice calls between both IP communicators are Ok , but video advantage shows the same image in local and remote window. I seems like the ip comm or the UC...

Dear all, I am using CCM5.1. I am generating the Call Report daily through CDR Management.But Last two days I could not generate the Call Report. Bcz. When I am going to generate the report..It s showing a Meesage Like Below" Data is not available fo...

We are experiencing intermittent dropped calls on 3 phones; (2) 7942s and (1) 7962. The drop calls happen between IP-phone-to-IP-phone and IP-phone-to-voice-gateway. The network consists of 5 Catalyst 4510's, 1 stacked 3750; 1 3845 (voice gateway); a...

Hello,1) I have Snom phones that show them using DSCP CS 5 (0x28) on captures.2) Asterisk servers showing DSCP AF31-low (0x1a)I have the following configuration for my Cisco 2560 switches;#Access-list with Snom SIP & RTPip access-list extended voip-t...