TelePresence and Video Infrastructure

Have an issue with some of my systems on TMS that I am receiving more No HTTP Response warnings.  I verified HTTPS is running properly on TMS and I have the SNMP and HTTP off, and HTTPS set on for the endpoints.  No firewall involved as systems are a...

I have systems running various firmware versions including: F9.3.4 (MXP Series) TC7.3.X (Series) CE8.2.1 (Series) X8.8.2  (VCS) X8.5.1 (VCS) 4.5(1.71) (Codian) 4.5(1.89) (Codian) J4.7 (MPS) 2.0.1 (Acano/CMS) We have been directed to upgrade SSL to cu...

Dear All, I am implementing CMS for the first time, i need some clarification on configuring: Customer Existing environment : 27x C40,Old Endpoints MCU 5310 with 5 HD Ports Old Registration VCS 20x Non-Tra Calls, 100x Tra Calls,H323 SIP Old Conferenc...

Does anyone know how to remove the 64bit block cyphers from the MXP VTC systems. We have to remove the from the /etc/ssh/sshd_config file ?? Also after doing that will I still be able to remote (SSH) into the system ?   Telnet is a no go.

Hello, is it possible to place video call between two sx10 without cucm/vcs systems? Thank you in advance

Hi.. We have a Profile 55’’ Single screen system.   We are not getting any audio output through speakers integrated in display unit.   We have checked the Codec output by connecting external speakers with codec and its working fine.   Now we are sus...

Hi team, would you please help me, i have a Cisco Mx 300 and the client need to connect second mornitor for the presentation but i did some configs and still not signal on the second monitor, can someone help how to do the comfigs please help..

Hi, Is there a way for me to disable support for Anonymous SSL ciphers on the SX80?

Hello, One of my mx700s during the call does not receive or send more audio even if it is not lost. In log peripherals.log I found this error repeated 2017-04-26T15:45:44.147+00:00 SalaPresidenteLitta E4:AA:5D:A2:53:C1 kernel: loop: Write error at by...

Good morning I want to know which are the differences between both DX80 endpoints: CP-DX80-K9 and CS-DX80-K9?

Is there any documentation explaining the differences between upgrading our Telepresence Software from TC7.3.8 to CE8.3.1? I'm currently aware of the changes with the Remote Controls and the Touch Pads but I'm trying to find more information regardin...

i have sip call from sx80 end point  TP end point register to VCSc version x6.1 and routed through CUCM 11.1 and again routed through Acano 1.9  we are seeing call is not connected and logs show request timeout 408 in VCSC & CUCM , and bye message

I have a mic60 mic but the cable was damaged. I have no guarantee. What cable can I use from another manufacturer to replace it since I have the connector euroblock but not the cable